Sharp DX-C202 User Manual / Operation Manual ▷ View online
Connecting the Machine
This section describes connecting the machine to a computer and a telephone line.
Connecting with a Computer Using a USB Cable
• USB 2.0 interface cable is not supplied. Obtain a USB cable that is correct for the computer you
are using.
• USB connection with a Macintosh is only possible via the computer’s standard USB port.
1.
Remove the cable cover.
CES068
2.
Connect the square-shaped connector of the USB 2.0 cable to the USB port.
CES096
3.
Connect the opposite end's flat connector to your computer's USB interface or USB hub.
Connecting the Machine
63
4.
Attach the cable cover.
CES094
• For details about installing printer drivers for USB connection, see the instructions provided on the
driver CD-ROM.
Connecting with a Digital Camera Using a USB Cable
This machine supports direct printing, which allows you to print images taken with a digital camera by
connecting the camera directly to the machine. The following describes how to connect the machine to a
digital camera.
connecting the camera directly to the machine. The following describes how to connect the machine to a
digital camera.
• Use the USB cable bundled with your digital camera.
• Make sure your digital camera supports PictBridge.
• Make sure your digital camera supports PictBridge.
1.
Confirm that both the machine and the digital camera are turned on.
2.
Open the cover of the USB flash disk port, connect the USB cable, and then connect the
other end of the cable to your digital camera.
other end of the cable to your digital camera.
CES196
When the machine recognizes the digital camera as a PictBridge device, "PictBridge
Connecting...", then "Ready" will appear on the machine’s control panel.
Connecting...", then "Ready" will appear on the machine’s control panel.
2. Getting Started
64
3.
When a digital camera is not connected to the machine, store the USB cable in a location
where it will not be damaged.
where it will not be damaged.
• For details about the printing method, see p.145 "PictBridge Printing".
• Make sure to close the cover of the USB flash disk port after use.
• Make sure to close the cover of the USB flash disk port after use.
Connecting with a Network Cable
Follow the procedure below to connect the machine to a computer through a network.
Prepare the hub and other network devices before connecting the 10BASE-T or 100BASE-TX cable to
the machine's Ethernet port.
Prepare the hub and other network devices before connecting the 10BASE-T or 100BASE-TX cable to
the machine's Ethernet port.
• Do not connect the Ethernet port of the machine to a network that may supply excess voltage,
such as a telephone line. Doing so may result in fire or electric shock
• Use shielded Ethernet cable. Unshielded cables create electromagnetic interference that could
cause malfunctions.
• The Ethernet cable is not supplied with this machine. Select your cable according to the network
environment.
1.
Remove the cable cover.
CES068
Connecting the Machine
65
2.
Connect the Ethernet cable to the Ethernet port.
CES093
3.
Connect the other end of the cable to the network (e.g., a network hub).
4.
Attach the cable cover.
CES094
• For details about network environment settings, see p.70 "Configuring the Machine".
• For details about installing printer drivers for network connection, see the instructions provided on
• For details about installing printer drivers for network connection, see the instructions provided on
the driver CD-ROM.
Reading the LED lamps
1
2
CES095
1. Yellow: Flashes when 100BASE-TX or 10BASE-T is being used.
2. Green: Lights up when the machine is properly connected to the network.
2. Getting Started
66
Click on the first or last page to see other DX-C202 service manuals if exist.