Sharp DX-C202 User Manual / Operation Manual ▷ View online
Installing Option
This section describes how to install the optional paper feed unit.
Installing the Paper Feed Unit (Tray 2)
• Touching the prongs of the power cable's plug with anything metallic constitutes a fire and
electric shock hazard.
• It is dangerous to handle the power cord plug with wet hands. Doing so could result in electric
shock.
• Before installing or removing options, always disconnect the power cord plugs from the wall
outlet and allow time for the main unit to fully cool. Failing to take these precautions could result
in burns.
in burns.
• The machine weighs approximately 30.0 kg (66.2 lb.). When moving the machine, use the
inset grips on both sides, and lift slowly in pairs. The machine will break or cause injury if
dropped.
dropped.
• Lifting the paper feed unit carelessly or dropping may cause injury.
• Before moving the machine, unplug the power cord from the wall outlet. If the cord is
unplugged abruptly, it could become damaged. Damaged plugs or cords can cause an
electrical or fire hazard.
electrical or fire hazard.
• The machine should always be lifted by two people.
• Tray 1 is required to print using the optional paper feed unit. Without Tray 1, paper jams will occur.
• Do not grip the tray areas when moving the machine.
• Tray 1 is required to print using the optional paper feed unit. Without Tray 1, paper jams will occur.
• Do not grip the tray areas when moving the machine.
Installing Option
79
1.
Check that the package contains paper feed unit.
CER004
2.
Turn off the power, and then unplug the machine's power cord from the wall outlet.
3.
Remove the adhesive tape from the optional paper feed unit.
CER023
4.
Lift using the inset grips on both sides of the machine.
CES052
2. Getting Started
80
5.
There are three upright pins on the optional paper feed unit. Align them with the holes on
the underside of the machine, and then carefully lower the machine onto them.
the underside of the machine, and then carefully lower the machine onto them.
CER005
6.
After installing the option, print the configuration page to confirm the installation.
If it is installed properly, “Tray 2” will appear under “Paper Input” on the configuration page.
• After installing the optional paper feed unit, select tray 2 in the printer driver. For details, see the
printer driver Help.
• If the optional paper feed unit is not installed properly, reinstall it following this procedure. If you
cannot install it properly even after attempting reinstallation, contact your sales or service
representative.
representative.
• For details about printing configuration page, see p.283 "Printing the Configuration Page".
• For details about loading paper in tray 2, see p.104 "Loading Paper in Tray 2".
• For details about loading paper in tray 2, see p.104 "Loading Paper in Tray 2".
Installing Option
81
Paper and Other Media
This section describes supported and unsupported paper, paper precautions, details of each paper type
and the printable area.
and the printable area.
• All paper must be set vertically, regardless of the paper size.
Supported Paper for Each Tray
This section describes the type, size, and weight of paper that can be loaded in each tray. The capacity
of each paper tray is also provided.
of each paper tray is also provided.
2. Getting Started
82
Click on the first or last page to see other DX-C202 service manuals if exist.