DOWNLOAD Sharp DX-C202 Service Manual ↓ Size: 7.05 MB | Pages: 127 in PDF or view online for FREE

Loading Paper

This describes how to load paper into the paper tray and bypass tray.

• Do not pull out the paper tray forcefully. If you do, the tray might fall and cause an injury.

• When loading paper, take care not to trap or injure your fingers.

Loading Paper in Tray 1

The following example explains loading procedure for the standard paper tray (Tray 1).

• Before printing on paper other than envelopes, make sure that the fusing unit levers inside the front

cover are pulled up. Leaving the levers lowered can cause print quality problems when printing on
paper other than envelopes.

• Make sure paper is not stacked above the limit mark inside the tray. Misfeeds might occur.
• After loading paper in the tray, specify the paper type and size using the control panel to avoid

printing problems. This machine does not detect the paper size automatically.

• Do not mix different types of paper in the same paper tray.
• Do not move the side paper guides forcefully. Doing so can damage the tray.
• Do not move the end paper guide forcefully. Doing so can damage the tray.
• When inserting the tray, make sure it is not slanted. Inserting it at a slant can damage the machine.
• Curled paper may jam. Straighten curled paper before loading.

1.

Pull out tray 1 carefully with both hands.

CES059

Loading Paper

95

Place the tray on a flat surface.

2.

Push the metal plate down until it clicks into place to lock.

CER031

3.

Pinch the clip on the side paper guide and slide it to match the standard size.

CER032

CER082

When loading custom size paper, position the paper guide slightly wider than the actual paper
size.

2. Getting Started

96

4.

Pinch the front end paper guide and slide it inward to match the standard size.

CER034

CER113

When loading custom size paper, position the paper guide slightly wider than the actual paper
size.

5.

Load the new paper stack print side up.

Make sure paper is not stacked higher than the upper limit (upper line) marked inside the tray.

CER033

Slide the guides inward, until they are flush against the paper's sides.
Make sure the paper is not stacked higher than the projection on the side paper guides.

Loading Paper

97

CER083

6.

Check there are no gaps between the paper and the paper guides; both side and front
end paper guides.

CER076

If there is a gap between the paper and the front end paper guide, as in the example below, the
paper might not feed in correctly.

CER077

2. Getting Started

98