Sharp DX-C202 User Manual / Operation Manual ▷ View online
CER103
Slide the guides inward until they are flush against the paper's sides.
Make sure the paper is not stacked higher than the projection on the side paper guides.
Make sure the paper is not stacked higher than the projection on the side paper guides.
CER083
8.
Check there are no gaps between the paper and the paper guides; both side and front
end paper guides.
end paper guides.
CER105
If there is a gap between the paper and the front end paper guide, as in the example below, the
paper might not feed in correctly.
paper might not feed in correctly.
Loading Paper
103
CER106
9.
Carefully push tray 1 straight into the machine.
CES062
To avoid paper jams, make sure the tray is securely inserted.
• To reinsert the extender, you might have to push it with moderate force.
• The upper limit differs depending on paper type; thin paper or thick paper. Check the label inside
• The upper limit differs depending on paper type; thin paper or thick paper. Check the label inside
the tray to confirm the upper limit.
• The remaining paper indicator on the right front side of the paper tray shows approximately how
much paper is remaining.
• For details about paper types supported by the machine, see p.82 "Paper and Other Media".
• For details about the paper settings, see p.114 "Specifying Paper Type and Paper Size".
• For details about the paper settings, see p.114 "Specifying Paper Type and Paper Size".
Loading Paper in Tray 2
The following example explains the loading procedure for Tray 2.
2. Getting Started
104
• Before printing on paper other than envelopes, make sure that the fusing unit levers inside the front
cover are pulled up. Leaving the levers lowered can cause print quality problems when printing on
paper other than envelopes.
paper other than envelopes.
• Make sure paper is not stacked above the limit mark inside the tray. Misfeeds might occur.
• After loading paper in the tray, specify the paper type and size using the control panel to avoid
• After loading paper in the tray, specify the paper type and size using the control panel to avoid
printing problems. This machine does not detect the paper size automatically.
• Do not mix different types of paper in the same paper tray.
• Do not move the side paper guides forcefully. Doing so can damage the tray.
• Do not move the end paper guide forcefully. Doing so can damage the tray.
• When inserting the tray, make sure it is not slanted. Inserting it at a slant can damage the machine.
• Do not move the side paper guides forcefully. Doing so can damage the tray.
• Do not move the end paper guide forcefully. Doing so can damage the tray.
• When inserting the tray, make sure it is not slanted. Inserting it at a slant can damage the machine.
1.
Lift and pull Tray 2 carefully, and then pull it out with both hands.
CER070
Place the tray on a flat surface.
2.
Press down on the bottom plate until it clicks.
CER071
Loading Paper
105
3.
Pinch the clips on the side paper guide, and then adjust the guide to the paper size.
CER072
4.
Pinch the clip on the end paper guide and align the arrow with the paper size.
CER086
5.
Load the new paper stack print side up.
Make sure paper is not stacked higher than the upper limit (upper line) marked inside the tray.
CER073
2. Getting Started
106
Click on the first or last page to see other DX-C202 service manuals if exist.