Sharp DX-C202 User Manual / Operation Manual ▷ View online
• Sticky originals such as translucent paper
• Thin, highly flexible originals
• Thick originals such as postcards
• Bound originals such as books
• Transparent originals such as OHP transparencies or translucent paper
• Originals that are wet with toner or white out
• Thin, highly flexible originals
• Thick originals such as postcards
• Bound originals such as books
• Transparent originals such as OHP transparencies or translucent paper
• Originals that are wet with toner or white out
Unscannable image area
Even if you correctly place originals in the ADF or on the exposure glass, margins of a few millimeters on
all four sides of the original might not be scanned.
all four sides of the original might not be scanned.
CES107
Margins when using exposure glass
In copier mode
In scanner mode
In fax mode
Top
3 mm
0 mm
1 mm
Right
3 mm
0 mm
1 mm
Left
3 mm
0 mm
1 mm
Bottom
3 mm
0 mm
2 mm
Margins when using ADF
In copier mode
In scanner mode
In fax mode
Top
3 mm
0 mm
0 mm
Right
3 mm
0 mm
1 mm (Letter, Legal)
0 mm (other sizes)
0 mm (other sizes)
Placing Originals
119
In copier mode
In scanner mode
In fax mode
Left
3 mm
0 mm
1 mm (Letter, Legal)
0 mm (other sizes)
0 mm (other sizes)
Bottom
3 mm
2 mm
2 mm
Placing Originals
This section describes the procedure for placing originals on the exposure glass and in the ADF.
• Do not place originals before any correction fluid and toner has completely dried. Doing so may
make marks on the exposure glass that will appear on copies.
• The original in the ADF takes precedence over the original on the exposure glass if you place
originals both in the ADF and on the exposure glass.
• Because colors made by marker or highlighter pen on originals are difficult to reproduce, they
might not appear on copies, or might appear as different colors.
Placing originals on the exposure glass
The exposure glass enables you to scan and send documents that cannot be fed into the ADF.
• Do not lift the ADF forcefully. Otherwise, the cover of the ADF might open or be damaged.
1.
Lift the ADF.
Be careful not to hold the input tray when lifting the ADF, for the tray might be damaged.
2. Getting Started
120
2.
Place the original face down on the exposure glass. The original should be aligned to the
rear left corner.
rear left corner.
CES070
3.
Lower the ADF.
Hold down the ADF with your hands when using thick, folded, or bound originals and the ADF
cannot be lowered completely.
cannot be lowered completely.
Placing originals in the Auto Document Feeder
By using the ADF, you can scan multiple pages at once.
• Do not place different size originals in the ADF at once.
• Straighten curls in the originals before placing them in the ADF.
• To prevent multiple sheets from being fed at once, fan the pages of your original before placing
• Straighten curls in the originals before placing them in the ADF.
• To prevent multiple sheets from being fed at once, fan the pages of your original before placing
them in the ADF.
• Place the original squarely.
1.
Adjust the guides according to the size of the original.
CES108
Placing Originals
121
2.
Place the aligned originals face up in the ADF. The last page should be on the bottom.
CES200
• When placing originals longer than A4, pull out the ADF tray's extenders.
2. Getting Started
122
Click on the first or last page to see other DX-C202 service manuals if exist.