DOWNLOAD Sharp DX-C202 Service Manual ↓ Size: 7.05 MB | Pages: 127 in PDF or view online for FREE

• Fan envelopes, and then align their edges before loading.

CER108

• When fanning envelopes, make sure they are not stuck together. If they are stuck together,

separate them.

• When fanning envelopes, make sure the envelope flaps are not stuck together. If they are stuck

together, separate them.

• Before loading envelopes, flatten them out so that their curl does not exceed that shown in the

illustration below.

CER109

• If the curl is severe, flatten out the envelopes using your fingers, as shown in the illustration below.

CER110

Paper and Other Media

91

• You may not be able to perform duplex printing on 8 " × 13 ", 8

1

/

2 

" × 13 ", Folio (8

1

/

4

 " × 13 "),

or 16K (195 mm × 267 mm) size paper in the following cases:

• PCL printer driver

When [Gradation:] in [Print Quality] is set to [Fine]

• PostScript 3 printer driver

When [Print Quality:] in [Printer Features] is set to [Best Quality]

Unsupported Types of Paper

Avoid using the following paper as they are not supported by this machine.

• Paper meant for an ink-jet printer
• Bent, folded, or creased paper
• Curled or twisted paper
• Torn paper
• Wrinkled paper
• Damp paper
• Dirty or damaged paper
• Paper that is dry enough to emit static electricity
• Paper that has already been printed onto, except a preprinted letterhead.

Malfunctions are especially likely when using paper printed on by other than a laser printer (e.g.
monochrome and color copiers, ink-jet printers, etc.)

• Special paper, such as thermal paper, aluminum foil, carbon paper and conductive paper
• Paper that is heavier or lighter than the specified limitations
• Paper with windows, holes, perforations, cutouts, or embossing
• Adhesive label paper on which the adhesive under-layer or base paper is exposed
• Paper with clips or staples
• Do not use ink-jet printer paper because it may stick to the fusing unit and cause a paper jam.
• Do not load OHP transparencies. Load translucent media only.
• Do not use paper that has already been printed onto by other printers.

• When loading paper, take care not to touch the surface of the paper.
• Even supported types of paper may cause paper jams or malfunctions if the paper is not in good

condition.

2. Getting Started

92

Paper Storage Precautions

Paper should always be stored properly. Improperly stored paper might result in poor print quality,
paper jams, or printer damage.
Recommendations are as follows:

• Avoid storing paper in areas that are excessively cold, hot, humid, or dry.
• Avoid exposing paper to direct sunlight.
• Store on a flat surface.
• Keep paper in its original packaging.

Printable Area

The following diagrams show the areas of paper that the machine can print onto.
Be sure to set the print margins correctly using the settings of the application in which it was created.
Paper

CER001

1

2

4

3

3

4

1. Print area

2. Feed direction

3. Approximately 4.2 mm (0.17 inches)

4. Approximately 4.2 mm (0.17 inches)

Paper and Other Media

93

Envelope

CER117

4

1

2

3

3

3

1. Print area

2. Feed direction

3. Approximately 10 mm (0.39 inches)

4. Approximately 15 mm (0.59 inches)

• The print area may vary depending on the paper size, printer language and printer driver settings.
• For better envelope printing, we recommend you set the right, left, top, and bottom print margins to

at least 15 mm (0.59 inches) each.

2. Getting Started

94