DOWNLOAD Sharp DX-C202 Service Manual ↓ Size: 7.05 MB | Pages: 127 in PDF or view online for FREE

• If metal objects, or water or other fluids fall inside this machine, you must turn off its power

immediately. After turning off the power, be sure to disconnect the power cord plug from the
wall outlet. Then contact your service representative and report the problem. Do not use the
machine. Doing so could result in fire or electric shock.

• Do not touch this machine if a lightning strike occurs in the immediate vicinity. Doing so could

result in electric shock.

• Keep the polythene materials (bags, gloves, etc.) supplied with this machine away from babies

and small children at all times. Suffocation can result if polythene materials are brought into
contact with the mouth or nose.

• Do not incinerate toner (new or used) or toner containers. Doing so risks burns. Toner will ignite

on contact with naked flame.

• Do not store toner (new or used) or toner containers anywhere near naked flames. Doing so

risks fire and burns. Toner will ignite on contact with naked flame.

• Do not crush or squeeze toner containers. Doing so can cause toner spillage, possibly resulting

in dirtying of skin, clothing, and floor, and accidental ingestion.

• Store toner (new or used), toner containers, and components that have been in contact with

toner out of reach of children.

• If toner or used toner is inhaled, gargle with plenty of water and move into a fresh air

environment. Consult a doctor if necessary.

Installing the Machine

43

• If toner or used toner gets into your eyes, flush immediately with large amounts of water. Consult

a doctor if necessary.

• If toner or used toner is swallowed, dilute by drinking a large amount of water. Consult a doctor

if necessary.

• When moving the machine, use the inset grips on both sides. The machine will break or cause

injury if dropped.

• Do not look into the lamp. It can damage your eyes.

• During operation, rollers for transporting the paper and originals revolve. A safety device has

been installed so that the machine can be operated safety. But take care not to touch the
machine during operation. Otherwise, an injury might occur.

• Removed tape is dirty. Be careful not to let it touch your hands or clothes.
• Leave the protective materials in place while moving the machine.
• Lower the machine slowly and carefully to prevent trapping your hands.
• Do not grip on the tray area when lifting the machine.
• Do not allow paper clips, staples, or other small objects to fall inside the machine.
• Keep uncovered print cartridges away from direct sunlight.
• Do not touch the print cartridge's photo conductor unit.

CER088

2. Getting Started

44

• Do not touch the ID chip on the side of the print cartridge as indicated in the illustration below.

CES032

1.

Remove the plastic bag.

2.

Lift the machine with another person using the inset grips on both sides of the machine.

CES052

3.

Remove the protective materials attached on the machine's exterior. Do not remove tapes
going into the inside of the machine.

CES155

The actual machine may come with protective materials attached in different positions. Make sure
to check the machine's exterior for all protective materials, and remove them completely.

Installing the Machine

45

4.

Open the ADF cover.

CES048

5.

Move the lever slightly to the machine rear, and then pull it up to unlock the paper feed
roller.

CES039

6.

Lift the paper feed roller slightly to remove it.

CES050

2. Getting Started

46