DOWNLOAD Sharp MX-M182 / MX-M182D (serv.man4) Service Manual ↓ Size: 4.28 MB | Pages: 40 in PDF or view online for FREE

MX-M232D  (AR-SP10/AR-RP10)  4 - 1

For unpacking, refer to the figure below.

Turn the main switch of the machine to the “OFF” position and then
remove the power plug of the machine from the outlet.

1) Remove the document cover.

Lift the document cover from the machine and tilt it to the rear side to
remove it.

2)  Remove the right cabinet.

Remove the screws and remove the right cabinet.

3) Remove the document glass and the right document glass holder.

Remove the screws, remove the document glass from the machine,
and then remove the right document glass holder.

4) Attach the SPF glass holder.

Fit the SPF glass holder to the document glass.
Attach the document glass to the machine and fix it with the screws.

MX-M232D  (AR-SP10/AR-RP10) 4 - 2

5) Attach the right cabinet.

Reattach the right cabinet to its original position and fix it with the
screws.

6) Cut out the cut-out portion.

Cut out the cut-out portion of the rear cabinet with nippers or the like.
At this time, be careful about the orientation of the nippers so that the
cut plane of the rear cabinet is flat.

7) Attach the automatic document feeder.

Insert the hinge portions of the document feeder into the mounting por-
tions of the machine by holding the feeder at an angle toward the rear
side.

8) Connect the relay connector.

Connect the harness of the automatic document feeder to the connec-
tor of the machine and tighten the screws on the connector.

9) Remove the filament tape.

Remove the filament tape located in the positions shown in the illustra-
tion.

10)  If the optical unit shifts and recognizes the boundary between 
the OC glass and SPF glass cover, perform SIM 53-8. 

MX-M232D  (AR-D36/D37) 5 - 1

Lift the document cover from the machine and tilt it to the rear side to 
remove it.

Remove the screw. Remove the rear cabinet and the rear cabinet 
cover.

Remove the two screws and remove the rear cover.

Part name

Quantity

Screw M4 x 12 (Fixing plate)

10

Fixing plate

4

Paper size label

1

(1)

(1)

(1)

(2)

(1)

(1)

(1)

(1)

(1)

(3)

(4)

MX-M232D  (AR-D36/D37) 5 - 2

•  The machine (1-tray model)

Cut out the portion shown in the illustration with nippers or the like.

•  The machine (2-tray model)

Press the portion shown in the illustration with a screwdriver or the 
like to remove it.

Remove the rear cover which is attached to the 250-sheet paper feed 
unit.

Remove the rear cover (upper stage) from the 2x250-sheet paper feed 
unit.

Put the machine on the 250-sheet paper feed unit, and fix with the fixing 
plates and the screws.

•  The machine (1-tray model) + 250-sheet paper feed unit

•  The machine (2-tray model) + 250-sheet paper feed unit