Sharp MX-BMX1 Service Manual ▷ View online
Replacement Adjustment
20 October 2010
3-19
AREA A
3.4.3 INFEED TRANSPORT MODULE
1. Remove connectors [A] (
x2 ).
2. Cut tie wrap [B] .
3. Remove E-clip [C] ( x1 ).
4. Remove pin to the Infeed transport module.
3. Remove E-clip [C] ( x1 ).
4. Remove pin to the Infeed transport module.
[A]
[C]
[B]
20 October 2010
3-20
AREA A
3.4.4 INFEED TRANSPORT WHEEL
1. Remove Infeed transport module (
3.4.3 ).
2. Remove nuts [A] ( x3 ).
3. Remove E-clip [B] ( x1 ).
3. Remove E-clip [B] ( x1 ).
[A]
[B]
Replacement Adjustment
20 October 2010
3-21
AREA A
3.4.5 INFEED MOTOR M1 & SENSOR Q2
1. Remove Infeed transport wheel (
3.4.4 ).
2. Remove screws [A] ( x3 ).
3. Pull out the Infeed motor M1 & sensor Q2.
3. Pull out the Infeed motor M1 & sensor Q2.
NOTE: The sensor Q2 is located on the motor.
[A]
20 October 2010
3-22
AREA A
3.4.6 SIDE GUIDES
Removal Front
1. Remove Infeed module (
1. Remove Infeed module (
3.4.1 ).
2. Remove screw [A] and [B] to the Front side guide [C] ( x2 ).
3. Same procedure on the Rear side guide [D].
3. Same procedure on the Rear side guide [D].
Replacement
1. Reverse the removal procedure.
1. Reverse the removal procedure.
NOTE: Make sure that you are using the correct screws (M4 x 8mm) when
reinstalling the side guides. If you are using longer screws, you may damage
the side guide shaft.
Adjustment
1. Adjust Side guide parallelism (
1. Adjust Side guide parallelism (
3.9.2 ).
[B]
[A]
[D]
[C]
Click on the first or last page to see other MX-BMX1 service manuals if exist.