Sharp MX-BMX1 Service Manual ▷ View online
Replacement Adjustment
20 October 2010
3-7
COVERS
3.3 COVERS
3.3.1 FRONT AND REAR COVER
1. Open top cover.
2. Remove screws [A] to Front cover ( x5 ).
3. Remove screws [B] to Rear cover ( x4 ).
4. Loosen screw [C] ( x1 ).
2. Remove screws [A] to Front cover ( x5 ).
3. Remove screws [B] to Rear cover ( x4 ).
4. Loosen screw [C] ( x1 ).
NOTE: Unhook the Rear cover.
[A]
[B]
[C]
20 October 2010
3-8
COVERS
3.3.2 INFEED COVER
[B]
[A]
1. Remove Front and Rear cover (
3.3.1 ).
2. Remove screws [A] ( 2 ).
3. Support Infeed Cover.
4. Remove screws [B] to remove Infeed Cover.
3. Support Infeed Cover.
4. Remove screws [B] to remove Infeed Cover.
NOTE: Remove screws in this order to avoid bending front frame part.
WARNING
Infeed cover is very heavy and could cause injury if it falls down.
Replacement Adjustment
20 October 2010
3-9
COVERS
3.3.3 INFEEDER
1. Open the Top Cover.
2. Remove screws [A] ( x4 ).
3. Disconnect connector [B].
4. Lift out the Infeeder.
2. Remove screws [A] ( x4 ).
3. Disconnect connector [B].
4. Lift out the Infeeder.
[A]
[B]
20 October 2010
3-10
COVERS
3.3.4 OUTFEED COVER
[B]
1. Set the machine to A4.
2. Remove Stacker module (
2. Remove Stacker module (
3.8.1 ).
3. Remove Front and Rear cover (
3.3.1 ).
4. Remove screws [A] ( x2 ).
5. Remove screws [B] ( x2 ).
6. Remove screws [C] ( x2 ).
7. Turn Fold Gate [D] halfway to its downmost position.
8. Pull out lower end of the Outfeed Cover and lift it up enough to clear the Out-
5. Remove screws [B] ( x2 ).
6. Remove screws [C] ( x2 ).
7. Turn Fold Gate [D] halfway to its downmost position.
8. Pull out lower end of the Outfeed Cover and lift it up enough to clear the Out-
feed Sensor [E].
10. Pull out upper end of the Outfeed Cover and lower it until it touches the Fold
Gate.
11. Turn Fold Gate to its uppermost position and remove Outfeed cover.
[A]
[D]
[C]
[E]
Click on the first or last page to see other MX-BMX1 service manuals if exist.