Sharp MX-BM50 (serv.man2) Service Manual ▷ View online
BM-1-16
11 Feb 2013
Booklet Maker
Installation
BOOKLET MAKER INSTALLATION
[H]
Rail Unit
1. If installing a Rail Unit [A] , install it according to pictures.
NOTE: If the Rail unit is installed at a later time the height adjustment of the Booklet maker has
to be redone.
If Trimmer will be installed extend the Rail unit with a rail extension [B] by tightening plugs and
screws ( x4) [C].
If both Trimmer and Square folder will be installed extend Rail unit with two rail extensions [D] by
tighten plugs and screws ( x8) [E].
2. Push the Booklet maker onto the rail.
[A]
[B]
[C]
[D]
[E]
[G]
[F]
Continued on next page.
BM-1-17
11 Feb 2013
Booklet Maker
Installation
BOOKLET MAKER INSTALLATION
8. Ensure the Docking screws ( x2) are in their outermost positions [H]
9. Dock the Booklet maker with the Finisher..
9. Dock the Booklet maker with the Finisher..
10. Install End bracket [F] with screws ( x4) [G].
BM-1-18
11 Feb 2013
BOOKLET MAKER INSTALLATION
1.3.3 ADJUSTMENTS
1. Remove screws [A] ( x6) and remove Bookler maker front cover .
2. Loosen screws [B] ( x3).
2. Loosen screws [B] ( x3).
3. Remove screws [C] ( x2)
4. Remove the Booklet maker rear cover by lifting and unhooking it.
[C]
Front and Back cover removal
[A]
[B]
BM-1-19
11 Feb 2013
Booklet Maker
Installation
BOOKLET MAKER INSTALLATION
1. The covers of the Booklet maker and the finisher should be aligned.
Also see page BM-1-15.
1.3.4 DOCKING THE MX-BM50 TO THE FINISHER
Continued on next page
Click on the first or last page to see other MX-BM50 (serv.man2) service manuals if exist.