Sharp VENTA HANDHELD (serv.man8) Service Manual ▷ View online
8. As with the above the terminal number is also displayed on all screens so
the operator can determine which terminal is being used.
Sharp Electronics (UK) Ltd – Paul Burton
32 of 40
Venta
+
Operation & Programming Manual January 2005 – Version 1.0
9. The following screen is shown to confirm a Bill Print request has been
received by the control POS after Print Bill has been selected
10. If the Move key is selected the current opened Table can be moved to
another Table. Enter the new Table number and press Enter. The message
“Table Move Successful” will be displayed. When the table has been
successfully moved confirmation will be made from the Control POS
Sharp Electronics (UK) Ltd – Paul Burton
33 of 40
Venta
+
Operation & Programming Manual January 2005 – Version 1.0
11. The following screens are displayed when Pay is selected. They form the
payment screen. Multiple entries can be made to show split tender. When
the payment is complete the “Finalise” key should be selected. This will
the payment is complete the “Finalise” key should be selected. This will
confirm the entered payments to the POS.
Sharp Electronics (UK) Ltd – Paul Burton
34 of 40
Venta
+
Operation & Programming Manual January 2005 – Version 1.0
9. UPX200 Resetting Procedure
It may be necessary as a result of Battery Failure or Low Charge OR
Application corruption to carry out a FULL reset on the UPX200. This will
Application corruption to carry out a FULL reset on the UPX200. This will
effectively return the unit to a factory default. The procedure is a s follows :-
1. Whilst depressing the green on/off switch insert and depress gently the
stylus pen into the reset switch on the rear of the UPX200.
2. When the unit has switched off press the numeric 5 key and whilst
holding it down press the green on/off switch, after a few seconds
(approx 3) the unit will restart with a System Menu displayed.
3. Select Option 8 and press enter DOC Delete will be displayed with a
percentage complete.
4. Press any key followed by “0”. The unit will reboot and load the default
Operating System followed by the screen calibration utility.
5. Calibrate the screen and install the Application Software as above.
Sharp Electronics (UK) Ltd – Paul Burton
35 of 40
Venta
+
Operation & Programming Manual January 2005 – Version 1.0
Click on the first or last page to see other VENTA HANDHELD (serv.man8) service manuals if exist.