JBL ENCOUNTER (serv.man4) EMC - CB Certificate ▷ View online
- Page 45 of 51 -
www.nemko.com
Report No. 27772
TRF No.:IECEN60950_1B
2.1.1.5 c1) TABLE: max. V, A, VA test
N/A
Voltage (rated)
(V)
Current (rated)
(A)
Voltage (max.) (V) Current (max.)
(A)
VA (max.)
(VA)
supplementary information:
2.1.1.5 c2) TABLE: stored energy
N/A
Capacitance C (µF)
Voltage U (V)
Energy E (J)
supplementary information:
E=0,5 CU² x 10
-6
2.2
TABLE: evaluation of voltage limiting components in SELV circuits
N/A
Component (measured between)
max. voltage (V)
(normal operation)
Voltage Limiting Components
V peak
V d.c.
Fault test performed on voltage limiting components
Voltage measured (V) in SELV circuits
(V peak or V d.c.)
supplementary information:
S-c=Short circuit
- Page 46 of 51 -
www.nemko.com
Report No. 27772
TRF No.:IECEN60950_1B
2.5
TABLE: limited power sources
N/A
Circuit output tested: …….
Measured Uoc (V) with all load circuits
disconnected: …….
disconnected: …….
I
sc
(A)
VA
Meas.
Limit
Meas.
Limit
Normal condition
Single fault: …..
supplementary information:
S-c=Short circuit, O-c=Open circuit
2.10.2
Table: working voltage measurement
N/A
Location
RMS voltage (V)
Peak voltage (V) Comments
supplementary information:
2.10.3 –
2.10.4
2.10.4
TABLE: clearance and creepage distance measurements
N/A
clearance cl and creepage
distance dcr at/of:
distance dcr at/of:
Up
(V)
U r.m.s.
(V)
required cl
(mm)
cl
(mm)
required
dcr (mm)
dcr
(mm)
Functional: Live – Neutral
before fuse
before fuse
Basic: Live – Protective Earth
Reinforced: Primary –
Secondary
Secondary
supplementary information:
See appended table C.2 for internal dista nces of transformer(s)
2.10.5
TABLE: distance through insulation measurements
N/A
distance through insulation di at/of:
Up
(V)
test voltage
(V)
required di
(mm)
di
(mm)
supplementary information:
- Page 47 of 51 -
www.nemko.com
Report No. 27772
TRF No.:IECEN60950_1B
4.3.8
TABLE: Batteries
N/A
Battery category.......................................:
No Batteries in unit.
Manufacturer............................................:
Type / model ............................................:
Voltage ....................................................:
V
Capacity ..................................................:
mAh
Tested and Certified by (incl. Ref. No.).......:
Circuit protection diagram:
MARKINGS AND INSTRUCTIONS (1.7.12, 1.7.15)
Location of replaceable battery
N/A
Language(s):
Close to the battery
In the servicing instructions
In the operating instructions
- Page 48 of 51 -
www.nemko.com
Report No. 27772
TRF No.:IECEN60950_1B
4.3.8
TABLE: Batteries
N/A
The tests of 4.3.8 are applicable only when
appropriate battery data is not available
appropriate battery data is not available
No Batteries in unit.
Is it possible to install the battery in a reverse
polarity position?
polarity position?
Temperature
Measured temperature: Ref. 4.5
Manufacturer recommended maximum temperature:
Manufacturer recommended maximum temperature:
°
C
Non-rechargeable batteries
Rechargeable batteries
Discharging
Unintentional
charging
charging
Charging
Discharging
Reversed
charging
charging
Meas.
current
current
Manuf.
spec.
spec.
Meas.
current
current
Manuf.
spec.
spec.
Meas.
current
current
Manuf.
spec.
spec.
Meas.
current
current
Manuf.
spec.
spec.
Max
current
during
normal
conditions
current
during
normal
conditions
Max
current
during fault
conditions
current
during fault
conditions
supplementary information:
Test results:
No batteries in unit.
Verdict
- Chemical leaks
N/A
- Explosion of the battery
- Emission of flame or expulsion of molten
metal
metal
- Electric strength test of equipment after
completion of tests
completion of tests
supplementary information:
Click on the first or last page to see other ENCOUNTER (serv.man4) service manuals if exist.