Harman Kardon SB 16 (serv.man9) EMC - CB Certificate ▷ View online
Clause
Requirement - Test
Result - Remark
Verdict
TÜV SÜD Product Service GmbH
Report reference No.:081-61102-000
Electrical Safety
F10Y2-X dev.DOC
Ridlerstr. 65
2006-11-02
D-80339 München
Page 45 of 52
Test Report National land Group Differences IEC 60065 7
th
Ed. Rev. 00 / 2006-02
GROUP DIFFERENCES
CONTENTS
Add the following annexes:
Annex ZA (normative) Other international
publications quoted in this standard with the
references of the relevant European publications
publications quoted in this standard with the
references of the relevant European publications
Annex ZB (normative) Special national conditions
Annex ZC (normative) A-deviations
Added. P
3.1
Add the following indent at the end of the list:
- exposure to excessive sound pressures from
headphones or earphones.
headphones or earphones.
NOTE A new method of measurement is
described in EN 50332-1, Sound system
equipment: Headphones and earphones
associated with portable audio equipment –
Maximum sound pressure level measurement
methodology and limit considerations – Part 1:
General method for ”one package equipment”,
and in EN 50332-2, Sound system equipment:
Headphones and earphones associated with
portable audio equipment – Maximum sound
pressure level measurement methodology and
limit considerations – Part 2: Guidelines to
associate sets with headphones coming from
different manufacturers.
described in EN 50332-1, Sound system
equipment: Headphones and earphones
associated with portable audio equipment –
Maximum sound pressure level measurement
methodology and limit considerations – Part 1:
General method for ”one package equipment”,
and in EN 50332-2, Sound system equipment:
Headphones and earphones associated with
portable audio equipment – Maximum sound
pressure level measurement methodology and
limit considerations – Part 2: Guidelines to
associate sets with headphones coming from
different manufacturers.
No headphones and
earphones.
earphones.
N
4.1.1
Replace the text of the note by:
NOTE For ROUTINE TEST reference is made to
EN 50333.
EN 50333.
Replaced. P
5.1.i)
Add the following note:
NOTE For RATED POWER CONSUMPTION
mesurements of TVs reference is made to EN
60107.
mesurements of TVs reference is made to EN
60107.
No TV apparatus.
N
Clause
Requirement - Test
Result - Remark
Verdict
TÜV SÜD Product Service GmbH
Report reference No.:081-61102-000
Electrical Safety
F10Y2-X dev.DOC
Ridlerstr. 65
2006-11-02
D-80339 München
Page 46 of 52
Test Report National land Group Differences IEC 60065 7
th
Ed. Rev. 00 / 2006-02
6.1
Replace the entire subclause by:
Apparatus including a potential source of ionizing
radiation shall be so constructed that personal
protection against ionizing radiation is provided
under normal operating conditions and under
fault conditions.
radiation shall be so constructed that personal
protection against ionizing radiation is provided
under normal operating conditions and under
fault conditions.
Compliance is checked by measurement under
the following conditions:
In addition to the normal operating conditions, all
controls adjustable from the outside BY HAND,
by any object such as a tool or a coin, and those
internal adjustments or pre-sets which are not
locked in a reliable manner, are adjusted so as to
give maximum radiation whilst maintaining an
intelligible picture for 1 h, at the end of which the
measurement is made.
the following conditions:
In addition to the normal operating conditions, all
controls adjustable from the outside BY HAND,
by any object such as a tool or a coin, and those
internal adjustments or pre-sets which are not
locked in a reliable manner, are adjusted so as to
give maximum radiation whilst maintaining an
intelligible picture for 1 h, at the end of which the
measurement is made.
NOTE Soldered joints and paint lockings are
examples of adequate locking.
examples of adequate locking.
The amount of ionizing radiation is regulated by
European Council Directive 96/29/Euratom of 13
May 1996. This directive requires that at any
point 10 cm from the outer surface of the
apparatu, the dose-rate shall not exceed 1μSv/h
(0,1 Mr/h) taking account of the background
level.
Moreover, the measurement shall be made under
fault conditions causing an increase of the high-
voltage, provided an intelligible picture is
maintained for 1 h, at the end of which the
measurement is made.
A picture is considered to be intelligible if the
following conditions are met:
- a scanning amplitude of at least 70% of the
usable screen width;
- a minimum luminance of 50 cd/m² with locked
blank raster provided by a test generator;
- a horizontal resolution corresponding to at least
1,5 MHz in the centre, with a similar vertical
degradation; not more than over flashover per 5
min.
European Council Directive 96/29/Euratom of 13
May 1996. This directive requires that at any
point 10 cm from the outer surface of the
apparatu, the dose-rate shall not exceed 1μSv/h
(0,1 Mr/h) taking account of the background
level.
Moreover, the measurement shall be made under
fault conditions causing an increase of the high-
voltage, provided an intelligible picture is
maintained for 1 h, at the end of which the
measurement is made.
A picture is considered to be intelligible if the
following conditions are met:
- a scanning amplitude of at least 70% of the
usable screen width;
- a minimum luminance of 50 cd/m² with locked
blank raster provided by a test generator;
- a horizontal resolution corresponding to at least
1,5 MHz in the centre, with a similar vertical
degradation; not more than over flashover per 5
min.
Replaced. P
13.3.1
Delete note 4.
Deleted. P
14
Delete note 4 and note5.
Deleted. P
15.1.1
Delete note 1 and note 2.
Deleted. P
15.2
Delete note 2.
Deleted. P
16.1
Delete note 1.
Deleted. P
Clause
Requirement - Test
Result - Remark
Verdict
TÜV SÜD Product Service GmbH
Report reference No.:081-61102-000
Electrical Safety
F10Y2-X dev.DOC
Ridlerstr. 65
2006-11-02
D-80339 München
Page 47 of 52
Test Report National land Group Differences IEC 60065 7
th
Ed. Rev. 00 / 2006-02
16.2
Delete the note.
Deleted. P
20
Delete note 2.
Deleted. P
Annex B
Replace note 1 by:
In the CENELEC countries listed in IEC 62151,
special national conditions apply.
special national conditions apply.
Replaced P
Annex G
Delete the note.
Deleted. P
Annex J.2
Delete the notes of Table J.1.
Deleted. P
Annex N
Add after the introduction:
For ROUTINE TEST reference is made to EN
50333.
50333.
Added. P
Bibliography Add the following standards:
EN 60332-1: 2000,
Sound system equipement: Headphones and earphones
associated with portable audio equipment –Maximum sound pressure level
measurement methodology and limit considerations – Part 1: General method
for ”one package equipment”.
measurement methodology and limit considerations – Part 1: General method
for ”one package equipment”.
PrEN 50332-2 (uder consideration),
Sound system equipement: Headphones
and earphones associated with portable audio equipment – Maximum sound
pressure level measurement methodology and limit considerations – Part
2:Guidelines to associate sets with headphones coming from different
manufacturers.
pressure level measurement methodology and limit considerations – Part
2:Guidelines to associate sets with headphones coming from different
manufacturers.
Add the following notes for the standards indicated:
N
IEC 60130
NOTE
Parts 9 and 17: 1998 are harmonized as Ens (not modified).
IEC 60169
NOTE
Partly harmonized in the EN 60169/HD 134 series (not modified).
IEC 60173
NOTE
Harmonized as HD 27 S1: 1978 (not modified).
IEC 60335-2-
56
56
NOTE
Harmonized as EN 60335-2-56: 1997 (not modified).
IEC 60335-2-
82
82
NOTE
Harmonized as EN 60335-2-82: 2000 (not modified).
IEC 60695
NOTE
Harmonized as EN 60695 series (not modified).
IEC 61040
NOTE
Harmonized as EN 61040: 1992 (not modified).
IEC 61558-2-
1
1
NOTE
Harmonized as EN 61558-2-1: 1997 (not modified).
IEC 61558-2-
4
4
NOTE
Harmonized as EN 61558-2-4: 1997 (not modified).
IEC 61558-2-
6
6
NOTE
Harmonized as EN 61558-2-6: 1997 (not modified).
Clause
Requirement - Test
Result - Remark
Verdict
TÜV SÜD Product Service GmbH
Report reference No.:081-61102-000
Electrical Safety
F10Y2-X dev.DOC
Ridlerstr. 65
2006-11-02
D-80339 München
Page 48 of 52
Test Report National land Group Differences IEC 60065 7
th
Ed. Rev. 00 / 2006-02
Annex ZA
(normative)
Other international publications quoted in this standard with the references
of the relevant European publications
⎯
This European Standard incorporates by dated or undated reference, provisions
from other publications. These normative references are cited at the appropriate
places in the text and the publications are listed hereafter. For dated references,
subsequent amendments to or revisions of any of these publications apply to this
European Standard only when incorporated in it by amendment or revision. For
undated references the latest edition of the publication referred to applies
(including amendments).
from other publications. These normative references are cited at the appropriate
places in the text and the publications are listed hereafter. For dated references,
subsequent amendments to or revisions of any of these publications apply to this
European Standard only when incorporated in it by amendment or revision. For
undated references the latest edition of the publication referred to applies
(including amendments).
NOTE When an international standard has been modified by common
modification, indicated by (mod), the relevant EN/HD applies.
modification, indicated by (mod), the relevant EN/HD applies.
P
P
Click on the first or last page to see other SB 16 (serv.man9) service manuals if exist.