Sharp LC-40LE831E Handy Guide ▷ View online
Issued by:
CE After Sales Service
July 2011
Adjustment Process
10. White Balance Adjustment
For white balance adjustment, adjust the offset values on pages 11/24.
[Condition of the unit for inspection] : Modulated light (+16)
AV MODE: DYNAMIC
Active Backlight: OFF
OPC: OFF
Asing Time: Min, 60 minute
[Input signal condition]
: HDMI 1080i 15IRE (LO), 78IRE (HI)
[Adjustment reference device] : Minolta CA-210
[Adjustment procedure]
1) Display the current adjustment status at R/G/B_GAIN (HI). (Page 11/24 of process adjustment)
The signal of 78IRE is input.
2) Read the value of the luminance meter. x=0.272, y =0.277
3) Change R_GAIN (HI)/ B_GAIN (HI) (Adjustment offset value) on page 11/24 of process adjustment so that the values of the luminance meter
approach x=0.272 and y =0.277.
(Basically, G is not changed. If adjustment fails with R and B, change G. When G is lowered, the weaker of R or B must be fixed.)
4) Display the adjustment status of the current R/G/B_GAIN (LO).
The signal of 15IRE is input.
Change R_GAIN (LO)/ B_GAIN (LO) (adjustment offset value) on page 11/24 of process adjustment so that the values of the luminance
meter approach x =0.272 and y = 0.277.
5) Both HI and LO are repeating the step from 1 to 4 until becoming an aim value.
[Adjustment reference standard value]
Adjustment spec +/- 0.002
Inspection spec +/- 0.004 (point LO)
Adjustment spec +/- 0.001
Inspection spec +/- 0.002 (point HI)
6) After completing adjustments, set EEP SAVE (Page 24/24) to ON in the process menu to save the white balance adjustment value
Thank You
Issued by:
CE After Sales Service
July 2011
Thank You
Issued by:
CE After Sales Service
July 2011
Thank You
Issued by:
CE After Sales Service
July 2011
