Sharp MX-TM10 (serv.man3) Service Manual ▷ View online
4
4
4-13
4-13
Disassembly and assembly > Periodic Parts Replacement, Consumable Parts, and Cleaning Parts > Removing the scratch prevention sheet (rear)
Disassembly and assembly > Periodic Parts Replacement, Consumable Parts, and Cleaning Parts > Removing the scratch prevention sheet (rear)
Removing the scratch prevention sheet (rear)
1) Remove the trimmer unit from the finisher.
2) Remove 3 screws at the front side, and 3 screws at the rear side.
x3
x3
F-4-32
3) Remove the rear side cables from 6 cable guides.
x6
F-4-33
4) Remove 2 resin rings, 1 pulley, 1 parallel pin, and 1 bearing and remove the feeder top unit.
F-4-34
4
4
4-14
4-14
Disassembly and assembly > Periodic Parts Replacement, Consumable Parts, and Cleaning Parts > Removing the scratch prevention sheet (rear)
Disassembly and assembly > Periodic Parts Replacement, Consumable Parts, and Cleaning Parts > Removing the scratch prevention sheet (rear)
5) Remove 2 E rings, 1 resin flange, 2 pulleys, 2 parallel pins, 1 belt, and 1 bearing from the rear side. Remove 1 E ring and 1 bearing from the front side.
F-4-35
6) Remove the paper eject pass unit.
F-4-36
7) Rotate the pressure roller unit in the direction of the arrow and remove the pressure roller unit, belt and 4 rollers.
F-4-37
4
4
4-15
4-15
Disassembly and assembly > Periodic Parts Replacement, Consumable Parts, and Cleaning Parts > Removing the scratch prevention sheet (rear)
Disassembly and assembly > Periodic Parts Replacement, Consumable Parts, and Cleaning Parts > Removing the scratch prevention sheet (rear)
8) Remove E ring, pulley, parallel pin, and bearing at the front side.
9) Remove E ring and bearing at the rear side. Remove the belt and roller unit, and remove the scratch prevention sheet (rear).
F-4-38
Note:
When installing the paper
eject pass unit, attach so
that the roller unit's paddle
(center) is on the bottom
side with the projection
of the pressure roller unit
positioned at the bottom of
the stopper solenoid lever.
eject pass unit, attach so
that the roller unit's paddle
(center) is on the bottom
side with the projection
of the pressure roller unit
positioned at the bottom of
the stopper solenoid lever.
4
4
4-16
4-16
Disassembly and assembly > Solenoids > Removing the paddle solenoid (SL102)
Disassembly and assembly > Solenoids > Removing the paddle solenoid (SL102)
Solenoids
Removing the paddle solenoid (SL102)
1)Remove the trimmer unit from the
finisher.
2)Remove the waste paper box.
3) Remove 2 far side connectors and remove 2 screws. Remove 3 front side screws and pull out 3 pins.
x2
x2
x3
F-4-39
4)Remove the registration unit in the direction of the arrow.
F-4-40
5) Remove the cable from 4 cable guides at the registration unit entrance side and remove 2 connectors.
x2
x4
F-4-41
Click on the first or last page to see other MX-TM10 (serv.man3) service manuals if exist.