Sharp MX-TM10 (serv.man3) Service Manual ▷ View online
4
4
4-21
4-21
Disassembly and assembly > Motors > Removing the press motor (M105)
Disassembly and assembly > Motors > Removing the press motor (M105)
Removing the feed motor (M101)
1)Separate the finisher from the host machine.
2)Remove the cutter unit.
3)Remove 1 connector, 2 screws, and remove the feed motor.
x1
x2
F-4-50
Removing the press motor (M105)
1)Separate the finisher from the host machine.
2)Remove the cutter unit.
3)Remove 1 connector, 1 screw, and remove the press motor unit.
x1
x1
F-4-51
4
4
4-22
4-22
Disassembly and assembly > Motors > Removing the front estrangement motor (M103)
Disassembly and assembly > Motors > Removing the front estrangement motor (M103)
Removing the rear estrangement motor (M104)
1)Separate the finisher from the host machine.
2)Remove the cutter unit.
3)Remove 1 connector, 2 screws, and remove the rear estrangement motor.
x1
x2
F-4-52
Removing the front estrangement motor (M103)
1)Separate the finisher from the host machine.
2)Pull out the saddle unit.
F-4-53
4
4
4-23
4-23
Disassembly and assembly > Motors > Removing the front estrangement motor (M103)
Disassembly and assembly > Motors > Removing the front estrangement motor (M103)
3)Pull out the saddle unit fully while pushing the stopper on both sides of the accuride rail in the direction of the arrow.
F-4-54
4)Remove 1 connector, 2 screws, and remove the front estrangement motor.
x1
x2
F-4-55
4
4
4-24
4-24
Disassembly and assembly > Sensors > Removing the waste paper full sensor (light emitting/S011(PCB2))
Disassembly and assembly > Sensors > Removing the waste paper full sensor (light emitting/S011(PCB2))
Sensors
Removing the waste paper full sensor (light emitting/S011(PCB2))
1) Remove the trimmer unit from the
finisher.
2) Remove 1 screw and pull out the connector.
x1
x1
F-4-56
3) Remove 2 hooks and remove the waste paper full sensor.
x2
F-4-57
Click on the first or last page to see other MX-TM10 (serv.man3) service manuals if exist.