Sharp MX-TM10 (serv.man3) Service Manual ▷ View online
4
4
Disassembly and assembly
Disassembly and
assembly
assembly
■Removing this Equipment
■List of Parts
■Main Units
■P e r i o d i c P a r t s
R e p l a c e m e n t ,
Consumable Parts, and
Cleaning Parts
■Solenoids
■Motors
■Sensors
■PCBs
F-4-1
4
4
4-2
4-2
Disassembly and assembly > Removing this Equipment
Disassembly and assembly > Removing this Equipment
Removing this Equipment
1) Open the finisher front door.
F-4-2
2) Remove the resin ring.
F-4-3
3) Remove the finisher front door in the direction of the arrow.
F-4-4
4) Remove the jam dial (top). Remove 1 screw and remove the jam dial (bottom).
x1
F-4-5
4
4
4-3
4-3
Disassembly and assembly > Removing this Equipment
Disassembly and assembly > Removing this Equipment
5) Remove 3 screws and remove the inner cover.
x3
F-4-6
6) Pull out the saddle unit.
F-4-7
7) Remove 5 screws and remove the top cover.
x5
F-4-8
8) Remove 1 screw and remove the steel plate. Remove 1 bearing and 2 resin rings. Remove the steel plate and remove the drive belt.
Note:
Be careful not to lose the
parallel pin on the inside of
the left side pulley.
parallel pin on the inside of
the left side pulley.
x1
F-4-9
4
4
4-4
4-4
Disassembly and assembly > Removing this Equipment
Disassembly and assembly > Removing this Equipment
9) Pull out the saddle unit fully while pushing the stopper on both sides of the accuride rail in the direction of the arrow.
F-4-10
10) Remove 2 connectors and remove cable from 3 locations of the wire saddle.
x3
x2
F-4-11
Click on the first or last page to see other MX-TM10 (serv.man3) service manuals if exist.