Sharp MX-TM10 (serv.man3) Service Manual ▷ View online
4
4
4-9
4-9
Disassembly and assembly > Main Units > Removing the cutter unit
Disassembly and assembly > Main Units > Removing the cutter unit
Main Units
Removing the cutter unit
1) Remove the finisher front door.
2) Remove the jam dial (top). Remove 1 screw and remove the jam dial (bottom).
x1
F-4-22
3) Remove 3 screws and remove the inner cover.
x3
F-4-23
4) Pull out the saddle unit.
F-4-24
5) Remove 5 screws and remove the top cover.
x5
F-4-25
4
4
4-10
4-10
Disassembly and assembly > Main Units > Removing the cutter unit
Disassembly and assembly > Main Units > Removing the cutter unit
6) Remove the cable from 3 locations of the wire saddle and remove 1 connector.
x3
x1
F-4-26
7) Remove 1 connector and secure the cable to the cable guide.
x1
x1
F-4-27
8) Remove the cutter unit from the trimmer unit frame.
MEMO:
Hold the cutter unit at the
locations shown below.
F-4-28
4
4
4-11
4-11
Disassembly and assembly > Periodic Parts Replacement, Consumable Parts, and Cleaning Parts > Removing the scratch prevention sheet (front top)
Disassembly and assembly > Periodic Parts Replacement, Consumable Parts, and Cleaning Parts > Removing the scratch prevention sheet (front top)
Periodic Parts Replacement, Consumable Parts, and Cleaning Parts
Removing the scratch prevention sheet (front top)
1) Remove the trimmer unit from the finisher.
2) Remove 2 screws, 2 pins and remove the scratch prevention sheet (front top).
x2
F-4-29
4
4
4-12
4-12
Disassembly and assembly > Periodic Parts Replacement, Consumable Parts, and Cleaning Parts > Removing the scratch prevention sheet (rear bottom)
Disassembly and assembly > Periodic Parts Replacement, Consumable Parts, and Cleaning Parts > Removing the scratch prevention sheet (rear bottom)
Removing the scratch prevention sheet (front bottom)
1) Remove the trimmer unit from the finisher.
2) Remove 1 screw and remove the scratch prevention sheet (front bottom).
MEMO:
Remove while lowering the
inlet lower guide unit.
x1
F-4-30
Removing the scratch prevention sheet (rear bottom)
1) Remove the trimmer unit from the finisher.
2) Remove 1 screw and remove the scratch prevention sheet (rear bottom).
MEMO:
Remove while lowering the
inlet lower guide unit.
x1
F-4-31
Click on the first or last page to see other MX-TM10 (serv.man3) service manuals if exist.