Sharp MX-TM10 (serv.man3) Service Manual ▷ View online
2
2
Technology
Technology
■
Basic Configuration
2
2
2-2
2-2
Technology > Basic Configuration > Functional Configuration
Technology > Basic Configuration > Functional Configuration
Basic Configuration
Functional Configuration
This equipment is mainly consists of a feed block, trimming block, paper delivery block, and
waste paper stack block.
waste paper stack block.
Feed block
[1]
[1]
Receives the booklet stitched by the saddle stitcher, and then delivers it to
the next block.
the next block.
T r i m m i n g
block [2]
block [2]
Trims the fore edge of the stitched booklet.
* When trimming is not done, the booklet just passes through the trimming
block.
* When trimming is not done, the booklet just passes through the trimming
block.
P a p e r
d e l i v e r y
block [3]
d e l i v e r y
block [3]
Applies pressure on the press rollers during transfer, delivery, registration,
and trimming of the stitched booklet.
* When trimming is not done, registration of the booklet is not done either.
and trimming of the stitched booklet.
* When trimming is not done, registration of the booklet is not done either.
Waste paper
stack block
[4]
stack block
[4]
Collects the waste paper generated when fore edges of booklets are
trimmed.
trimmed.
4. Waste paper stack block
1. Feed block
2. Trimming block
3. Paper delivery block
F-2-1
2
2
2-3
2-3
Technology > Basic Configuration > Component Configuration > Roller Layout
Technology > Basic Configuration > Component Configuration > Roller Layout
Overview of Electrical Circuitry
The operation sequence of this machine is controlled by the trimmer controller PCB.
Saddle stitcher
controller PCB
Motors
Sensors
Solenoids
Trimmer controller PCB
CPU
Communication
IC
Motor driver
F-2-2
Component Configuration
■
Roller Layout
Inlet roller (upper)
Inlet roller (lower)
Paper delivery roller (lower)
Press roller (lower)
Paper delivery roller (upper)
Press roller (upper)
F-2-3
2
2
2-4
2-4
Technology > Basic Configuration > Drive Configuration
Technology > Basic Configuration > Drive Configuration
■
Sensor Layout
Only the optical sensors on the feed path are shown below.
S101
Inlet sensor
S103
Paper delivery sensor
F-2-4
Drive Configuration
M101
SL102
M106
M104
M103
SL101
M102
M105
M101: Feed motor
M105: Press motor
M102: Registration motor
M106: Cutter motor
M103: Front estrangement motor
SL101: Stopper solenoid
M104: Rear estrangement motor
SL102: Paddle solenoid
F-2-5
Click on the first or last page to see other MX-TM10 (serv.man3) service manuals if exist.