DOWNLOAD Sharp MX-M1055 / MX-M1205 (serv.man2) Service Manual ↓ Size: 31.08 MB | Pages: 127 in PDF or view online for FREE

MX-M1205  AR-SU1 (STAMP UNIT)  20 – 1

MX-M1205

Service Manual

 

* When replacing the stamp cartridge, Refer to “Stamp cartridge

replacement” in the “User’s Guide” (PDF document) which is
stored in the hard disk of the machine. The user must be notified
of that. (Do not refer to “Stamp cartridge replacement procedure”
(Packed items).)

NOTE: Before installation, be sure to turn both the operation and

main power switches off and disconnect the power plug
from the power outlet. Make double sure that the data lamp
on the operation panel does not light up or blink when per-
forming installation.

1)

Open the DSPF unit, remove the OC mat.

2)

Remove the screw, and remove the paper exit PG cover.
Remove the screw.

Disengage the pawl, and remove the stamp case unit.

3)

Attach the stamp unit (Packed items) to the stamp case which
was removed from the DSPF unit with the installing screw
(Packed items). (Fix it together with the earth wire.)

* Arrange the harness of the stamp unit as shown below.

4)

Install the stamp case unit, and fasten it with the screw. Install
the earth wire. Connect the connector.

1

Stamp  unit

1

2

Stamp cartridge replacement procedure*

1

3

Stamp cartridge

3

4

Installing screw

1

MX-M1205  AR-SU1 (STAMP UNIT)  20 – 2

5)

Install the paper exit PG cover.

6)

Disengage the pawl, and open the stamp case unit.

Install the stamp cartridge (Packed items).

7)

Install the OC mat to the document table glass, and close the
DSPF unit.

1)

Connect the power plug of the machine to the power outlet,
and turn ON the main power switch and the operation panel
power switch.

MX-M1205  MX-EB11 (ENHANCED COMPRESSION KIT)  21 – 1

MX-M1205

Service Manual

 

NOTE: Before installation, be sure to turn both the operation and

main power switches off and disconnect the power plug
from the power outlet. Make double sure that the data lamp
on the operation panel does not light up or blink when per-
forming installation. 

NOTE: The "E7-48" error is occurred if install the older version of

MX-EB11 than the "04.00.A1." 
Check the version of the ACU (MAIN) and the ACU (DATA)
in SIM22-5, update the firmware if version is not "04.00.A1"
or newer.

1)

Remove the screw, and remove the rear cabinet.

2)

Remove the harness.

3)

Remove the screw, and remove the plate.

1

Scanner function expansion PWB

1

2

Screw

2

1

2

MX-M1205  MX-EB11 (ENHANCED COMPRESSION KIT)  21 – 2

1)

Connect the scanner function expansion PWB (packed item) to
the connector of the MFP control PWB, and fix it with the
screw (Packed item).

1)

Attach the part which is removed in the previous step, connect
the power plug of the machine to the power outlet, and turn ON
the main power switch and the operation panel power switch.

1)

Execute SIM22-10 to check to confirm that the combined
machine recognizes the MX-EB11.