DOWNLOAD Sharp MX-M1055 / MX-M1205 (serv.man2) Service Manual ↓ Size: 31.08 MB | Pages: 127 in PDF or view online for FREE

MX-M1205  MX-PN13A/B/C/D (PUNCH MODULE)  16 – 5

1)

Once remove the existing card fixing screw and stack the card
(Packed items No.8) on the existing card then fix with the
screw.

 

MX-M1205  MX-TM10 (TRIMMING MODULE)  17 – 1

MX-M1205

Service Manual

 

NOTE: When unpacking the trimmer unit, use manpower of two or

more persons.

1)

Remove the fixing tape from the paper folding unit.

NOTE: Installation must be executed in the sequence of the com-

plex machine body, the paper feed option, and the paper
exit option.

NOTE: Before installation, be sure to turn both the operation and

main power switches off and disconnect the power plug
from the power outlet. Make double sure that the data lamp
on the operation panel does not light up or blink when per-
forming installation.

NOTE: Because there is a cutter in the cutter unit, please don’t

insert fingers into the unit.

NOTE: When putting the cutter unit on a floor, put it so that the cut-

ter motor is in the lower side.

1)

Remove the sponge sheet.

1)

Open the front door of the finisher.

2)

Remove the resin E-ring, and remove the front door.

3)

Remove the jam dial and the screw.

4)

Remove the screw, and remove the inside cover.

1

Upper cover

1

2

Screw (Bind, M4 x 6)

7

3

Cutter  unit

1

4

Drive belt

1

5

Dust box holding member

1

6

Special tapping screw

1

7

Trimmer unit frame body

1

8

Accuride rail

1

9

Step screw (M4 x 6)

2

10

Plate

1

1

2

3

4

5

6

7

8

9

10

MX-M1205  MX-TM10 (TRIMMING MODULE)  17 – 2

5)

Use a nipper to cut out the dust-box blind section of the inside
cover.

1)

Pull out the saddle unit until it stops.

2)

Disconnect the connector at the rear of the saddle unit.

3)

Remove the plate and the belt. (The plate will be used later.)

4)

Remove the transport unit.

5)

Remove the discharge unit. 
Save the removed screws for later use.

MX-M1205  MX-TM10 (TRIMMING MODULE)  17 – 3

1)

Insert the pin at the rear of the accuride rail (Packed items
No.8) into the hole at the rear of the finisher.

NOTE: Fix the accuride rail with the screw removed in the pre-

vious procedure (Discharge unit removal).

NOTE: Insert the screw into the hole in the upper side of the

accuride rail.

2)

Fix the unit with the step screw (Packed items No. 9 Step
screw M4 x 6).

3)

Pull out the accuride rail installed in procedure 1) until it stops.

Hold the trimmer unit frame body (Packed items No. 7) as
shown in the figure below.

4)

Engage the frame of the trimmer unit with the step screw
attached in procedure 2),

5)

Fix the trimmer unit to the accuride rail with the screw (Packed
items No. 2 Bind M4 x 6).

1)

Put the cutter unit (Packed items No.3) on the trimmer unit.