Sharp MX-BM50 (serv.man2) Service Manual ▷ View online
BM-1-36
11 Feb 2013
Cover Feeder Installation
COVER FEEDER INSTALLATION
13. Set up the Booklet maker to A4/8.5 x 11” paper size.
14. Send one A4/8.5 x 11” job to the Booklet maker system.
15. Check that the covers are correctly fed into the Booklet maker.
16. A. Set up the Cover Feeder to Cover OFF and remove all covers from the bin.
14. Send one A4/8.5 x 11” job to the Booklet maker system.
15. Check that the covers are correctly fed into the Booklet maker.
16. A. Set up the Cover Feeder to Cover OFF and remove all covers from the bin.
Use the Purge mode to completely empty the Cover Feeder from covers.
B. Prepare a 15mm high stack of A3/11 x 17” covers.
C. Repeat step 19.
17. Set up the Booklet maker to A3/11 x 17” paper size.
18. Send one A3/11 x 17” job to the Booklet maker system.
19. Check that the covers are correctly fed into the Booklet maker.
18. Send one A3/11 x 17” job to the Booklet maker system.
19. Check that the covers are correctly fed into the Booklet maker.
Page intentionally blank
BM-1-38
11 Feb 2013
Trimmer Installation
TRIMMER INSTALLATION
1.5 TRIMMER INSTALLATION
1.5.1 ACCESSORY CHECK
[A]
Check the quantity and condition of the accessories in the box against the follow-
ing list:
NOTE: - The Installation Box is located in the trim bin on the Trimmer.
- The trim bin is tie wrapped on the rear.
- The Rail Extension is located in the packing material
Description Q’ty
A. Communication cable between the Booklet maker .............. 1
and the Trimmer
B. Power cord between the Booklet maker and Trimmer ......... 1
C. Rail extension ...................................................................... 1
B. Power cord between the Booklet maker and Trimmer ......... 1
C. Rail extension ...................................................................... 1
Plugs
................................................................................... 4
D. Cable protector ..................................................................... 1
E. Cable holder ......................................................................... 1
E. Cable holder ......................................................................... 1
[B]
[C]
[D]
[E]
BM-1-39
11 Feb 2013
TRIMMER INSTALLATION
1.5.2 INSTALLATION PROCEDURE
Unpacking
1. Remove all parts from the pallets.
2. Ensure all of the packing material is removed from the outside of the Trimmer.
3. Tilt the Trimmer to upright position.
2. Ensure all of the packing material is removed from the outside of the Trimmer.
3. Tilt the Trimmer to upright position.
WARNING
Two persons are required to tilt the Trimmer to the upright position.
Click on the first or last page to see other MX-BM50 (serv.man2) service manuals if exist.