Sharp MX-6500N / MX-7500N (serv.man12) Service Manual ▷ View online
MX-7500N MX-MF11 (MULTI BYPASS TRAY) 11 – 2
2) Fix the bracket with the screw.
3) Remove the multi bypass tray from the package.
NOTE: Use man power of two persons to lift the multi bypass
tray. (Refer to the figure below.)
C. Removal of the upper cabinet of the multi
bypass tray for LCT
1) Remove the screws and remove the upper cabinet.
MEMO: Remove the paper feed section with shifting it to the
direction of the arrow.
2) Mount the multi bypass tray on LCT and fix it with screws.
NOTE: Insert the connection pin to the positioning hole of the
multi bypass tray.
3) Connect the harnesses to LCT.
MEMO: Wire the harnesses through the cable clamp.
Screw hole
Screw hole
Connection pin
Connection pin
MX-7500N MX-MF11 (MULTI BYPASS TRAY) 11 – 3
4) Fix the upper cabinet with the screws.
MEMO: After fixing the cabinet, shift the paper feed section to
the direction of the arrow.
5) Open the front door of the LCT, and store the tab sheet
restraint plate to the place as shown in the figure below.
MX-7500N MX-TR14 (EXIT TRAY UNIT) 12 – 1
MX-7500N
Service Manual
[12] MX-TR14 (EXIT TRAY UNIT)
1. Unpacking
A. Packed items check
2. Installation
NOTE: Before installation, be sure to turn both the operation and
main power switches off and disconnect the power plug
from the power outlet. Make double sure that the data lamp
on the operation panel does not light up or blink when per-
forming installation.
A. Cabinet removal
1) Remove the screws (3 pcs.) and remove the front cabinet
upper of the right door.
2) Remove the screws (2 pcs.) and remove the cabinet upper of
the right door.
3) Remove the screw (1 pc.), and remove the inner cover of the
right door.
No.
Name
Quantity
1
Right paper exit unit
1
2
ADU right upper cabinet R
1
3
ADU right upper cabinet F
1
MX-7500N MX-TR14 (EXIT TRAY UNIT) 12 – 2
4) Remove the screws (6 pcs.).
(1) Step screw, (2) P tight, (3) S tight
5) Remove the right paper exit section.
B. Right paper exit unit dummy removal
1) Remove the screws (4 pcs.), and remove the right paper exit
PG upper.
NOTE: When removing, be careful of the pawls.
2) Remove the screws (7 pcs.) and remove the right paper exit
unit dummy.
Ԙ
ԙ
Ԛ
Pawls
Click on the first or last page to see other MX-6500N / MX-7500N (serv.man12) service manuals if exist.