Panasonic TH-86SQ1W (serv.man2) Service Manual ▷ View online
DIS-7
SECTION 2 DISASSEMBLY PROCEDURES
<86SQ1>
2.4. P2 module removal
1. Disconnect 7 connectors on the P2 module (Ref.No.29).
Note: Pay attention not to tear off the cable from the connector.
2. Remove 2 screws on connector CN9901 and remove the cables of AC inlet.
3. Remove a screw S3 and 9 Screw S9, and then remove the P2 module (Ref.No.29).
29
[CN9902]
[CN9901]
[CN904][CN902]
[CN903]
[CN905]
[CN906]
[CN904]
[CN902]
[CN903]
[CN905]
[CN9902]
[CN9901]
[CN906]
29
: Screw S3 (1pc) : Screw S9 (9pcs)
DIS-8
SECTION 2 DISASSEMBLY PROCEDURES
<86SQ1>
2.5. AC inlet removal
1. Remove 2 screws on connector CN9901 and remove the cables of AC inlet.
2. Remove a screw S1 and 2 screw S2, and then remove the AC ASSY (Ref.No.49) and the COVER_CABLE (Ref.No.19)
from the REAR_COVER_R (Ref.No.11).
49
19
[ CN9901 ]
S2
S1
11
29
DIS-9
SECTION 2 DISASSEMBLY PROCEDURES
<86SQ1>
2.6. P1 module removal
1. Disconnect 4 connectors on the P1 module (Ref.No30).
Note: Pay attention not to tear off the cable from the connector.
2. Remove a screw S3 and 7 screw S9, and then remove the P1 module (Ref.No30).
3. When replacing the P1 module, move the PCB-SUPPORT (Ref.No21) from original P1 module to new P1 module.
[CN904]
30
[CN901]
[CN905]
[CN903]
[CN903]
[CN901]
[CN904]
[CN905]
21
30
21
30
[ Back ]
: Screw S3 (1pc) : Screw S9 (7pcs)
DIS-10
SECTION 2 DISASSEMBLY PROCEDURES
<86SQ1>
2.7. FRC module removal
1. Disconnect 6 connectors on the FRC module (Ref.No31).
Note: Pay attention not to tear off the cable from the connector.
2. Remove 5 screw S9 and remove the FRC module (Ref.No31).
28
31
[CN415] [CN703] [CN410]
[CN416]
[CN414]
[CN413]
[CN415] [CN703]
[CN410]
[CN416]
[CN414]
[CN413]
31
: Screw S9 (5pcs)
Click on the first or last page to see other TH-86SQ1W (serv.man2) service manuals if exist.