Panasonic KV-S2087 (serv.man2) Service Manual ▷ View online
49
8.4.10.
Drive Roller 1 and 2
8.4.11.
Starting Sensor Board
(1) Remove the CIS Unit (B). (See 8.4.7.)
(2) Remove the Belt. (See 8.4.9)
(3) Lift up the Drive Roller 1 (arrow
(2) Remove the Belt. (See 8.4.9)
(3) Lift up the Drive Roller 1 (arrow
1
) and move it slightly
(arrow
2
).
(4) Lift up the right part of the Drive Roller 1 to remove
(arrow
3
).
(5) Remove the Drive Roller 2 in the same way.
(1) Remove the Drive Roller 1. (See 8.4.10.)
(2) Remove the 2 Screws A and Connector.
(3) Remove the Starting Sensor Board.
(2) Remove the 2 Screws A and Connector.
(3) Remove the Starting Sensor Board.
Drive Roller 1
Drive Roller 2
Drive Roller 1
1
2
3
Belt
Starting Sensor Board.
A
Connector
A
50
8.4.12.
Drive Roller 3
(1) Remove the Center Inner Cover. (See 8.2.10.)
(2) Remove the 2 Screws B to remove the Static Brush.
(3) Remove the Screw G and A to remove the Support Plate.
(4) Remove the 2 Screws B to remove the Paper Path Plate.
(2) Remove the 2 Screws B to remove the Static Brush.
(3) Remove the Screw G and A to remove the Support Plate.
(4) Remove the 2 Screws B to remove the Paper Path Plate.
(5) Remove the Drive Belt. (See 8.4.9.)
(6) Unlock the Boss 1 to remove the Gate Change Path.
(6) Unlock the Boss 1 to remove the Gate Change Path.
Reassembling Note:
Make sure that Boss 2 is locked properly.
Check if the Change Path Lever goes in conjunction with the
Gate Change Path. (Fig-1)
Check if the Change Path Lever goes in conjunction with the
Gate Change Path. (Fig-1)
B
B
B
B
Static Brush
Paper Path Plate
Reinforcement
Plate
Plate
A
G
Support Plate
Guide paper
Gate Change Path
Boss 1
Guide paper
Gate Change Path
Boss 2
Gate Change Path
Gate Change Path
Fig-1
Exit Change Lever
Straight Path
U-turn Path
See the 6.1. Paper Feed Mechanism
51
(7) Push the 2 Bosses of the Guide Paper to unlock (arrow
1
).
(8) Remove the Guide Paper by pushing inward (arrow
2
).
(9) Push the Drive Roller 3 inward ( arrow
3
).
(10) Remove the Drive Roller 3.
1
Boss
1
Push here
Guide Paper
2
3
52
8.4.13.
Imprinter Starting Board
8.4.14.
Imprinter Door Board
(1) Remove the Drive Roller 3. (See 8.4.12.)
(2) Remove the 2 Screws B and the Connector to remove the
(2) Remove the 2 Screws B and the Connector to remove the
Imprinter Starting Board..
(1) Remove the Drive Roller 3. (See 8.4.12.)
(2) Remove the Screws B and the Connector to remove the
(2) Remove the Screws B and the Connector to remove the
Imprinter Door Board.
B
Imprinter Starting Board
Imprinter Door Board
B
Connector
Click on the first or last page to see other KV-S2087 (serv.man2) service manuals if exist.