Panasonic KV-SS081 Service Manual ▷ View online
17
8 DISASSEMBLY INSTRUCTIONS
8.1.
Disassembly Flowchart
The following flowcharts indicate the disassembly sequence for the Exterior, Mechanical parts, Unit Components,
and Circuit Board assemblies
When reassembling, perform the steps in the reverse order unless otherwise instructed in the Reassembling Notes.
and Circuit Board assemblies
When reassembling, perform the steps in the reverse order unless otherwise instructed in the Reassembling Notes.
Note:
Disassembly flowchart explanation
* This sample flowchart shows that, to disassemble C, the procedures 1 and 2 must be performed first before proceeding to the
procedure 3.
procedure 3.
18
19
8.2.
Disassembling
8.2.1.
Flatbed Sheet
(1) Open the Document Cover.
(2) Push the center of the right edge (A) of the Flatbed Sheet
towards the left to slide the sheet.
(3) While slightly lifting the ear of the left side of the Flatbed
Sheet in the direction of the arrow (1), pull the sheet in the
direction of the arrow (2) to remove it.
direction of the arrow (2) to remove it.
20
8.2.2.
Document Cover
8.2.3.
Hinge L and Hinge R
8.2.4.
CONTROL Board's Cover
(1) Pull the Document Cover (in the direction of the arrows (2))
while pushing the tip of each Hinge on both sides inward (in
the direction of the arrows (1)) to release the cover from the
scanner.
the direction of the arrows (1)) to release the cover from the
scanner.
(1) Remove the Document Cover. (See 8.2.2.)
(2) While inserting the gap between Document Cover and
(2) While inserting the gap between Document Cover and
Hinge L with a flat-blade screwdriver, pull and remove the
Hinge L.
Then, also remove Hinge R in the same way.
Hinge L.
Then, also remove Hinge R in the same way.
(1) Remove the 2 screws that secure the CONTROL Board's
Cover.
Then, remove the cover.
Then, remove the cover.
Click on the first or last page to see other KV-SS081 service manuals if exist.