Sharp XV-Z201E (serv.man31) User Manual / Operation Manual ▷ View online
Introduction
-11
Operating the Remote Control
■ The remote control can be used to control the projector
within the ranges shown in the illustration.
Note
• The signal from the remote control can be reflected off a screen
for easy operation. However, the effective distance of the signal
may differ due to the screen material.
may differ due to the screen material.
When using the remote control:
• Be sure not to drop, or expose to moisture or high temperature.
• The remote control may malfunction under a fluorescent lamp.
Under that circumstance, move the projector away from the fluo-
rescent lamp.
rescent lamp.
Available Range of the Remote Control
Incorrect use of the batteries may cause them to leak or explode. Please follow the precautions below.
Caution
• Insert the batteries making sure the polarities correctly match the and marks inside the battery compart-
ment.
• Batteries of different types have different properties, therefore do not mix batteries of different types.
• Do not mix new and old batteries.
This may shorten the life of new batteries or may cause old batteries to leak.
• Remove the batteries from the remote control once they have run out, as leaving them can cause them to leak.
Battery fluid from leaked batteries is harmful to your skin, therefore be sure to first wipe them and then remove
them using a cloth.
them using a cloth.
• The batteries included with this projector may exhaust over a short period, depending on how they are kept.
Be sure to replace them as soon as possible with new batteries when they have run out.
• Remove the batteries from the remote control if you will not be using the remote control for a long time.
Inserting the Batteries
The batteries (two “AA” size) are included in
the package.
the package.
1
Pull down the tab on the cover
and remove the cover towards
the direction of the arrow.
and remove the cover towards
the direction of the arrow.
2
Insert the included batteries.
• Insert the batteries making sure the
polarities correctly match the
and
marks inside the battery compart-
ment.
3
Insert the lower tab of the
cover into the opening, and
lower the cover until it clicks
in place.
cover into the opening, and
lower the cover until it clicks
in place.
Remote control
Remote control
45˚
7 m
30˚
30˚
45˚
30˚
XV_Z201E_E_p04_12.p65
03.10.30, 12:16AM
11
-12
Accessories
Remote control
Power cord
(For U.K., Hong Kong
and Singapore)
21 pin RCA
conversion adaptor
conversion adaptor
(Supplied for Europe only)
Lens cap
Video cable
Two AA size batteries
(For Australia
and New Zealand)
Projector Operation manual
Screws for terminal cover
(For Europe except U.K.)
Note
• Depending on the region, projectors are shipped with only
one power cord (see above). Use the power cord that cor-
responds to the wall outlet in your country.
responds to the wall outlet in your country.
3 RCA to 15-pin D-sub cable (3.0 m)
AN-C3CP
DVI to 15-pin D-sub adaptor (20 cm)
AN-A1DV
DVI cable (3.0 m)
AN-C3DV
Note
• Some of the cables may not be available depending on the region. Please check with your nearest Sharp
Authorised Projector Dealer or Service Centre for replacement.
Optional accessories
Supplied accessories
Terminal cover
XV_Z201E_E_p04_12.p65
03.10.30, 12:16AM
12
Connections and Setup
Connections and Setup
XV_Z201E_E_p13_24.p65
03.10.30, 12:17AM
13
-14
Connecting the Projector to Other Devices
Before Connecting
Note
• Before connecting, be sure to unplug the power cord of the projector from the AC outlet and turn off
the devices to be connected. After making all connections, turn on the projector and then the other
devices.
When connecting a computer, be sure that it is the last device to be turned on after all the connec-
tions are made.
devices.
When connecting a computer, be sure that it is the last device to be turned on after all the connec-
tions are made.
• Be sure to read the operation manuals of the devices to be connected before making connections.
This projector can be connected to:
Video equipment:
■ A VCR, DVD player or other video equipment (See page 15.)
■ A DVD player or DTV* decoder (See page 17.)
*DTV is the umbrella term used to describe the new digital television system in the United States.
A computer using:
■ DVI to 15-Pin D-sub adapter (See page 21.)
■ A DVI cable (See page 22.)
■ An RS-232C cable (See page 23.)
Connecting the Power
Cord
Cord
Plug in the supplied power cord into
the AC socket on the rear of the pro-
jector.
the AC socket on the rear of the pro-
jector.
Supplied
accessory
accessory
-14
Power cord
XV_Z201E_E_p13_24.p65
03.10.30, 12:17AM
14
Click on the first or last page to see other XV-Z201E (serv.man31) service manuals if exist.