Sharp MX-BMX1 Service Manual ▷ View online
1-5
Installation
24 November 2010
BOOKLET MAKER INSTALLATION
1.3 BOOKLET MAKER INSTALLATION
1.3.1 MX-BMX1 ACCESSORY CHECK
Check the quantity and condition of the accessories in the box against the following list:
Description
Q’ty
A. Exit arm Catcher .................................................................. 1
B. Communication Cable to finisher ......................................... 1
C. Docking assembly ................................................................ 1
D. Shift tray plate ...................................................................... 1
E. Exit tray plate ....................................................................... 1
F. Powercord ............................................................................ 1
G. Terminator plug, will always be installed onto MX-BMX1 ..... 1
H. Terminator plug MX-TMX1 ................................................... 1
I. Interlock Jumper, will always be installed onto MX-BMX1 .. 1
J. Interlock Jumper MX-TMX1 ................................................. 1
K. Cable protector ..................................................................... 1
L. Cable protector sticker ........................................................ 1
M. Cable holder ......................................................................... 1
B. Communication Cable to finisher ......................................... 1
C. Docking assembly ................................................................ 1
D. Shift tray plate ...................................................................... 1
E. Exit tray plate ....................................................................... 1
F. Powercord ............................................................................ 1
G. Terminator plug, will always be installed onto MX-BMX1 ..... 1
H. Terminator plug MX-TMX1 ................................................... 1
I. Interlock Jumper, will always be installed onto MX-BMX1 .. 1
J. Interlock Jumper MX-TMX1 ................................................. 1
K. Cable protector ..................................................................... 1
L. Cable protector sticker ........................................................ 1
M. Cable holder ......................................................................... 1
[A]
[D]
[C]
[B]
[E]
[F]
[H]
[G]
[I]
[J]
[K]
[L]
[M]
1-6
24 November 2010
BOOKLET MAKER INSTALLATION
1.3.2 MX-BMX1 INSTALLATION PROCEDURE
Unpacking
1. Remove all parts from the pallet.
2. Slide the Booklet maker off the pallet by pulling the two cardboard handles [A]
2. Slide the Booklet maker off the pallet by pulling the two cardboard handles [A]
underneath the Booklet maker straight out.
WARNING
Two persons are required to slide the Booklet Maker off the pallet.
[A]
1-7
Installation
24 November 2010
BOOKLET MAKER INSTALLATION
Exit arm catcher
1. Remove the adhesive backing from the Exit arm catcher.
2. Install the Exit arm catcher on the finisher so that it will hold the Exit paper arm
2. Install the Exit arm catcher on the finisher so that it will hold the Exit paper arm
as high as possible. The nut on the Exit arm catcher should be centered over
the Exit paper arm, according to figure.
3. Lift up the Exit paper arm, and set it onto the Exit arm catcher [A].
[A]
1-8
24 November 2010
BOOKLET MAKER INSTALLATION
[A]
Copier exit tray
1. Make sure that the Exit paper arm is in the upper position [A].
2. Remove the finisher exit tray by removing screws [B] ( x 4).
3. Remove the plastic deflector [C], on the finisher exit tray.
2. Remove the finisher exit tray by removing screws [B] ( x 4).
3. Remove the plastic deflector [C], on the finisher exit tray.
[B]
[C]
Click on the first or last page to see other MX-BMX1 service manuals if exist.