Sharp MX-2630 Service Manual ▷ View online
MX-2630N MX-PN15B/C/D (PUNCH MODULE) 12 – 5
19) Place the shaft on the dent section at the right side of the plate.
20) Fix the front side with the screw.
21) Fix the right side with the screw.
22) Insert the guide plate (Packed item No. 3) from the right side of
the finisher.
23) Hook the pawls of the front side and right side to the flame of the
main unit, and fix the guide plate.
MX-2630N MX-PN15B/C/D (PUNCH MODULE) 12 – 6
24) Fix the front side with the screw.
25) Install the resist sensor (Packed item No.2).
26) Insert the resist sensor (Packed item No.2) from the right side of
the finisher.
27) Fix the resist sensor (Packed item No.2) to the frame of the fin-
isher with the screw.
28) Connect the connector, fix it to the wire saddle.
Check that the guide plate
passes through.
passes through.
Front side
Right side
Resist sensor (No.2) connector
Hopper (no.4) connector
MX-2630N MX-PN15B/C/D (PUNCH MODULE) 12 – 7
29) Install the punch unit (Packed item No.1).
30) Turn the punch unit with the operation section facing upward.
31) Insert the punch unit from the right side of the finisher.
32) Fix the punch unit to the frame of the finisher with the screws (x2).
33) Attach the stepping motor (Packed item No.7) from the right side
of the finisher.
34) Fix the stepping motor (Packed item No.7) to the frame of the fin-
isher with the screws (x2).
35) Connect each harness with the punch unit PWB.
Stepping motor (No.7) connector
Resist sensor (No.2) connector
MX-2630N MX-PN15B/C/D (PUNCH MODULE) 12 – 8
36) Connect the harness (Packed item No.8: Shorter harness) with
the punch unit PWB.
37) Connect the opposite side of the harness (Packed item No.8:
shorter harness) with the interface connector.
Stepping motor (No.7) connector
Resist sensor (No.2) connector
Harness (No.8)
Harness (no.8)
Harness (no.8)
Click on the first or last page to see other MX-2630 service manuals if exist.