DOWNLOAD Sharp MX-2630 Service Manual ↓ Size: 66.16 MB | Pages: 127 in PDF or view online for FREE

MX-2630N  MX-PN15B/C/D (PUNCH MODULE)  12 – 1

MX-2630N

Service Manual

 

1

Punch unit

1

2

Resist sensor

1

3

Guide plate

1

4

Hopper

1

5

Stay

1

6

Hopper

1

7

Stepping motor

1

8

Harness

1

9

Screw

15

MX-2630N  MX-PN15B/C/D (PUNCH MODULE)  12 – 2

NOTE: Be sure to install the punch unit before installing the finisher to

the main unit. In the case of installing the punch unit afterward,
remove the finisher from the main unit once.

NOTE: Before installation, be sure to turn both the operation and main

power switches off and disconnect the power plug from the
power outlet. Make double sure that the data lamp on the
operation panel does not light up or blink when performing
installation.

1)

Remove the tapes from the packing materials.

2)

When the finisher is connected to the main unit, disconnect the
interface cable and remove the finisher.

3)

Remove the rear cabinet of the finisher.

4)

Incline the upper part of the rear cabinet, and remove the rear
cabinet while lifting the pawls of the rear cabinet.

5)

Open the front cabinet of the finisher.

6)

Remove the knob.

7)

For MX-FN29 (Saddle finisher), remove the knob.

8)

Unscrew the screw fixing the inner cover.

Lift the pawls.

MX-2630N  MX-PN15B/C/D (PUNCH MODULE)  12 – 3

9)

For MX-FN29 (Saddle finisher), disconnect the interface connec-
tor connected to the inner cover.

10) Open the upper cover, and remove the resign ring.

11) Unscrew the screws (x2) at the front side, and remove the guide

plate.

12) Unscrew the screws (x2) at the right side, and remove the guide

plate.

MX-2630N  MX-PN15B/C/D (PUNCH MODULE)  12 – 4

13) Take out the guide plate.

* The guide plate taken out is unnecessary. Be sure to ask the
customer if it should be disposed of.

14) Insert the hopper (Packed item No.4) from the paper feeding side

of the finisher.

15) Pass the harness to the outside of the blade.

16) Fix the inserted hopper with the screw.

17) Pass the harness through the clamp, and fix it.

18) Insert the stay from the front side of the finisher.