Sharp MX-2610N / MX-3110N / MX-3610N (serv.man18) User Manual / Operation Manual ▷ View online
OPERATION GUIDE - FINISHER
file:///G|/Documents/Products/MX2610_3110_3610N/Operation%20Manual/MX3610OP_0122A1/mx3610_ex_ope/contents/01-037a.htm[24/03/2011 2:56:22 PM]
MX-2610N / MX-3110N / MX-3610N
FINISHER
OPERATIONS COMMON TO ALL MODES
This device outputs sorted paper while
staggering each set of paper. As needed, it
staples each set.
To punch holes in printed paper, install an
optional hole punch module.
Function names
Supplies
Finisher maintenance
Function names
The following describes the parts that appear when the finisher is open.
Tap the name to make its details pop up.
Tap the name to make its details pop up.
A finisher cannot be installed simultaneously with a saddle finisher.
Exercise caution when you turn on the power and when printing is taking place,
as the output tray may move up and down.
Supplies
The finisher requires the following staple cartridge:
Staple cartridge (approx. 5000 staples per cartridge x three cartridges)
MX-SCX1
Finisher maintenance
When the staple cartridge runs out of staples, a message will appear in the operation panel.
Follow the operation procedure to replace the staple cartridge.
OPERATION GUIDE - FINISHER
file:///G|/Documents/Products/MX2610_3110_3610N/Operation%20Manual/MX3610OP_0122A1/mx3610_ex_ope/contents/01-037a.htm[24/03/2011 2:56:22 PM]
Index
Contents
Operation
OPERATION GUIDE - FINISHER
file:///G|/Documents/Products/MX2610_3110_3610N/Operation%20Manual/MX3610OP_0122A1/mx3610_ex_ope/contents/01-037b.htm[24/03/2011 2:56:23 PM]
MX-2610N / MX-3110N / MX-3610N
FINISHER
OPERATIONS COMMON TO ALL MODES
<
8
steps in all >
Open the cover.
While pressing the lever
over to the left, slide the
finisher to the left until it
stops.
finisher to the left until it
stops.
Gently slide the finisher until it stops.
Lower the staple case
release lever and remove
the staple case.
the staple case.
Pull the staple case out to the right.
Remove the empty staple
cartridge from the staple
case.
case.
Replacing the cartridge
OPERATION GUIDE - FINISHER
file:///G|/Documents/Products/MX2610_3110_3610N/Operation%20Manual/MX3610OP_0122A1/mx3610_ex_ope/contents/01-037b.htm[24/03/2011 2:56:23 PM]
Index
Contents
Overview
Insert a new staple
cartridge into the staple
case as shown.
case as shown.
Push the staple cartridge in until it clicks
into place.
Replace the staple case.
Push the staple case in until it clicks into
place.
Slide the finisher back to
the right.
Gently slide the finisher back to the right
until it locks into its original position.
Close the cover.
Make a proof copy in staple sort function
to verify that stapling takes place
correctly.
Make a proof copy in staple sort function to verify that stapling takes place
correctly.
Click on the first or last page to see other MX-2610N / MX-3110N / MX-3610N (serv.man18) service manuals if exist.