Sharp AR-C330 (serv.man14) User Manual / Operation Manual ▷ View online
MODEL
AR-C330
DIGITAL FULL COLOUR
COPYING MACHINE
COPYING MACHINE
OPERATION MANUAL
DIGITAL FULL COLOUR
COPYING MACHINE
COPYING MACHINE
OPERATION MANUAL
Be sure to become thoroughly familiar with this manual to
gain the maximum benefit from the product.
gain the maximum benefit from the product.
Before installing this product, be sure to read the
installation requirements and cautions sections.
installation requirements and cautions sections.
Be sure to keep all operation manuals handy for reference
including this manual, the "Operation manual" and operation
manuals for any optional equipment which has been
installed.
including this manual, the "Operation manual" and operation
manuals for any optional equipment which has been
installed.
Required in IEC-950 (EN 60 950) - Europe
• The equipment should be installed near an accessible socket outlet for easy disconnection.
• The equipment should be installed near an accessible socket outlet for easy disconnection.
Required in Appendix ZB of BS 7002 (En 60 950) — United Kingdom
MAINS PLUG WIRING INSTRUCTIONS
In some areas, the "POWER" switch positions are marked "I" and " " on the copier instead of "ON" and
"OFF".
The symbol " " denotes the copier is not completely de-energized but in a stand-by condition at this
"POWER" switch position.
If your copier is so marked, please read "I" for "ON" and " " for "OFF".
"OFF".
The symbol " " denotes the copier is not completely de-energized but in a stand-by condition at this
"POWER" switch position.
If your copier is so marked, please read "I" for "ON" and " " for "OFF".
Caution!
For a complete electrical disconnection, pull out the main plug.
The socket-outlet shall be installed near the equipment and shall be easily accessible.
The socket-outlet shall be installed near the equipment and shall be easily accessible.
Warning
This is a class A product. In a domestic environment this product may cause radio interference in which case
the user may be required to take adequate measures.
the user may be required to take adequate measures.
Warranty
While every effort has been made to make this document as accurate and helpful as possible, SHARP Corporation
makes no warranty of any kind with regard to its content. All information included herein is subject to change
without notice. SHARP is not responsible for any loss or damages, direct or indirect, arising from or related to the
use of this operation manual.
© Copyright SHARP Corporation 2004. All rights reserved. Reproduction, adaptation or translation without prior
written permission is prohibited, except as allowed under copyright laws.
makes no warranty of any kind with regard to its content. All information included herein is subject to change
without notice. SHARP is not responsible for any loss or damages, direct or indirect, arising from or related to the
use of this operation manual.
© Copyright SHARP Corporation 2004. All rights reserved. Reproduction, adaptation or translation without prior
written permission is prohibited, except as allowed under copyright laws.
Trademark Acknowledgments
Microsoft®, Windows®, Windows® 95, Windows® 98, Windows® Me, Windows NT® 4.0, Windows® 2000,
Windows® XP and Internet Explorer® are registered trademarks or trademarks of Microsoft Corporation in the
U.S.A. and other countries.
IBM, PC/AT, and PowerPC are trademarks of International Business Machines Corporation.
Pentium is a registered trademark of Intel Corporation.
PCL is a trademark of the Hewlett-Packard Company.
Photoshop® is a registered trademark of Adobe Systems Incorporated.
Acrobat® Reader Copyright© 1987-2002 Adobe Systems Incorporated. All rights reserved.
Adobe, the Adobe logo, Acrobat, and the Acrobat logo are trademarks of Adobe Systems Incorporated.
NetWare is a registered trademark of Novell, Inc.
All other trademarks and copyrights are the property of their respective owners.
Windows® XP and Internet Explorer® are registered trademarks or trademarks of Microsoft Corporation in the
U.S.A. and other countries.
IBM, PC/AT, and PowerPC are trademarks of International Business Machines Corporation.
Pentium is a registered trademark of Intel Corporation.
PCL is a trademark of the Hewlett-Packard Company.
Photoshop® is a registered trademark of Adobe Systems Incorporated.
Acrobat® Reader Copyright© 1987-2002 Adobe Systems Incorporated. All rights reserved.
Adobe, the Adobe logo, Acrobat, and the Acrobat logo are trademarks of Adobe Systems Incorporated.
NetWare is a registered trademark of Novell, Inc.
All other trademarks and copyrights are the property of their respective owners.
NOTES
Considerable care has been taken in preparing this manual. If you have any comments or concerns about the
manual, please contact your nearest SHARP Service Department.
This product has undergone strict quality control and inspection procedures. In the unlikely event that a defect
or other problem is discovered, please contact your dealer or nearest SHARP Service Department.
Aside from instances provided for by law, SHARP is not responsible for failures occurring during use of the
product or its options, or failures due to incorrect operation of the product and its options, or other failures, or
for any damage that occurs due to use of the product.
manual, please contact your nearest SHARP Service Department.
This product has undergone strict quality control and inspection procedures. In the unlikely event that a defect
or other problem is discovered, please contact your dealer or nearest SHARP Service Department.
Aside from instances provided for by law, SHARP is not responsible for failures occurring during use of the
product or its options, or failures due to incorrect operation of the product and its options, or other failures, or
for any damage that occurs due to use of the product.
The display screens, messages, and key names shown in the manual may differ from those on the actual
machine due to product improvements and modifications.
machine due to product improvements and modifications.
The mains lead of this equipment is already fitted with a mains plug which is either a non-rewireable (moulded) or a
rewireable type. Should the fuse need to be replaced, a BSI or ASTA approved fuse to BS1362 marked or and of
the same rating as the one removed from the plug must be used.
Always refit the fuse cover after replacing the fuse on the moulded plug. Never use the plug without the fuse cover fitted.
In the unlikely event of the socket outlet in your home not being compatible with the plug supplied either cut-off the moulded
plug (if this type is fitted) or remove by undoing the screws if a rewireable plug is fitted and fit an appropriate type observing
the wiring code below.
rewireable type. Should the fuse need to be replaced, a BSI or ASTA approved fuse to BS1362 marked or and of
the same rating as the one removed from the plug must be used.
Always refit the fuse cover after replacing the fuse on the moulded plug. Never use the plug without the fuse cover fitted.
In the unlikely event of the socket outlet in your home not being compatible with the plug supplied either cut-off the moulded
plug (if this type is fitted) or remove by undoing the screws if a rewireable plug is fitted and fit an appropriate type observing
the wiring code below.
DANGER: The fuse should be removed from the cut-off plug and the plug destroyed immediately and disposed of in a safe
manner. Under no circumstances should the cut-off plug be inserted elsewhere into a 13A socket outlet as a serious electric
shock may occur.
manner. Under no circumstances should the cut-off plug be inserted elsewhere into a 13A socket outlet as a serious electric
shock may occur.
To fit an appropriate plug plug the mains lead, follow the instructions below:
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:
GREEN-AND-YELLOW:
Earth
BLUE: Neutral
BROWN: Live
BROWN: Live
As the colours of the wires in this mains lead may not correspond with coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured GREEN-AND YELLOW must be connected to the terminal in the plug which is marked with the
letter E, or by the safety earth symbol , or coloured green or green-and-yellow.
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked with theletter L or coloured red.
identifying the terminals in your plug, proceed as follows:
The wire which is coloured GREEN-AND YELLOW must be connected to the terminal in the plug which is marked with the
letter E, or by the safety earth symbol , or coloured green or green-and-yellow.
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked with theletter L or coloured red.
If you have any doubt, consult a qualified electrician.
WARNING: THIS APPARATUS MUST BE EARTHED.
WARNING: THIS APPARATUS MUST BE EARTHED.
1
The following pages contain samples of the various colour copying functions described in this manual. They are
designed to demonstrate the wide range of capabilities and applications for the Sharp AR-C330 digital full colour
copying machine.
designed to demonstrate the wide range of capabilities and applications for the Sharp AR-C330 digital full colour
copying machine.
Note that the samples shown on page 1 to 8 are not actual copies from AR-C330. The colours displayed may differ
from those of actual copies.
from those of actual copies.
Colour Copying with Special Features
1. Single colour copying (See page 3-26.)
The single colour function is used to produce copies using a selected single colour.
Original
Red
Purple
Green
Orange
Blue
Brown
COLOUR COPY SAMPLES
2
2. Neg./Pos. Reverse (See page 3-28.)
The NEG./POS. REVERSE function is used to transform a colour original into its complementary colours. If this
function is selected in the black/white mode, the black and white areas of the original will be reversed.
function is selected in the black/white mode, the black and white areas of the original will be reversed.
Original
3. Photo repeat (See page 3-32.)
PHOTO REPEAT is used to produce multiple copies of a photo on a single sheet of copy paper.
Copy (A4 or 8-1/2" x 11")
Copy (A3 or 11" x 17")
Colour copy
Black/white copy
Original
(90mm x 130mm or 3" x 5")
Original
(100mm x 150mm or 5" x 7")