Panasonic KV-S5055C (serv.man2) Service Manual ▷ View online
41
7.3.
Replacing Limited Life Parts
7.3.1.
Replacing Paper Feed Roller Module
(1) Turn off the scanner.
(2) Remove the current Paper Feed Module. (See 8.4.1.)
(3) Take out a new Paper Feed Module in the optional
"Roller Exchange Kit (KV-SS039)".
"Roller Exchange Kit (KV-SS039)".
(4) Install the new Paper Feed Module.
With the lever of the Paper Feed Roller Module lowered, insert
both protrusions into the grooves, and then slowly raise the
lever in the direction of the arrow until it clicks into place.
With the lever of the Paper Feed Roller Module lowered, insert
both protrusions into the grooves, and then slowly raise the
lever in the direction of the arrow until it clicks into place.
Note:
Make sure that the lever of the Paper Feed Roller module
is firmly locked. If the lever is not firmly locked, the lever
or the module may become damaged or may not
function correctly.
is firmly locked. If the lever is not firmly locked, the lever
or the module may become damaged or may not
function correctly.
42
7.3.2.
Replacing Double-feed Prevention Roller
(1) Turn off the scanner.
(2) Remove the current Double-feed Prevention Roller.
(See 8.5.12.)
(See 8.5.12.)
(3) Take out a new Double-feed Prevention Roller in the optional
"Roller Exchange Kit (KV-SS039)".
"Roller Exchange Kit (KV-SS039)".
(4) Install the new Double-feed Prevention Roller.
Align the shaped shaft with the notch in the roller mount, and
then insert the shaft in the notch.
Push the shaft on the opposite side until it clicks into place.
Align the shaped shaft with the notch in the roller mount, and
then insert the shaft in the notch.
Push the shaft on the opposite side until it clicks into place.
Note:
1. After you install the Double-feed Prevention Roller,
make sure that the shaft is inserted into the tab, and
that the shaft will not rotate or move.
If the roller is not installed correctly, it may cause
double feeding or a paper jam.
make sure that the shaft is inserted into the tab, and
that the shaft will not rotate or move.
If the roller is not installed correctly, it may cause
double feeding or a paper jam.
2. After replacing the Paper Feed Roller Module and
Double-feed Prevention Roller, execute "Clear Counter
for replacing roller" with Service Utility. (See 9.3.4.)
Double-feed Prevention Roller, execute "Clear Counter
for replacing roller" with Service Utility. (See 9.3.4.)
43
8 DISASSEMBLY INSTRUCTIONS
8.1.
Disassembly Flowchart
The flowchart indicates disassembly sequence for the Exterior, Mechanical parts, Unit Components, and Circuit Board
assemblies.
When reassembling, perform the steps in the reverse order unless otherwise instructed in Reassembling Notes.
assemblies.
When reassembling, perform the steps in the reverse order unless otherwise instructed in Reassembling Notes.
Note: Disassembly flowchart explanation
* This sample flowchart shows that, to disassemble C, the procedures 1 and 2 must be performed first before
proceeding to the procedure 3.
44
Click on the first or last page to see other KV-S5055C (serv.man2) service manuals if exist.