Harman Kardon AVR 265 EMC - CB Certificate ▷ View online
Page 3 of 5
Report No.: 163977
ATTACHMENT 4
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065J
No Items
Requirements
Result - Remark
Verdict
Applicable to electric airport
12 Reboil
Switch
No part of the reboil switch is
allowed to protrude into the water
pot, even if it is located above the m
aximum water level mark.
allowed to protrude into the water
pot, even if it is located above the m
aximum water level mark.
No electric airport
N/A
Applicable to AC adaptor
13
3-pin AC adaptor
(Appendix V)
(Appendix V)
Test report showing that the 3-pin
complied with sub-clauses 12.1 &
12.3 of SS 246 must be submitted.
complied with sub-clauses 12.1 &
12.3 of SS 246 must be submitted.
No AC adaptor
N/A
14
2-pin AC adaptor
(Appendix V)
(Appendix V)
The 2-pin (Appendix T) shall comply
with EN 50075.
with EN 50075.
N/A
15
Detachable
power supply
cord set not
supplied by
Registered
Supplier
power supply
cord set not
supplied by
Registered
Supplier
Registered Supplier who is not
supplying the detachable power
supply cord set together with the
AC Adaptor must provide written
instruction to its customer on the
type of approved detachable power
cord set to use.
supplying the detachable power
supply cord set together with the
AC Adaptor must provide written
instruction to its customer on the
type of approved detachable power
cord set to use.
N/A
Applicable to computer products
16
CD/DVD ROM
(used in
personal
computer)
(used in
personal
computer)
Test certificate showing that CD/DV
D ROM has complied with IEC 825
must be provided.
D ROM has complied with IEC 825
must be provided.
No CD/DVD ROM
N/A
17
Modem Card
(used in
personal
computer)
(used in
personal
computer)
Modem card incorporated in the
personal computer must be tested
at set level (sub-clauses 5.1 & 6 of
IEC 60950) or at component level.
personal computer must be tested
at set level (sub-clauses 5.1 & 6 of
IEC 60950) or at component level.
No modem
N/A
Applicable to ceiling fan and cycle fan
18
Ceiling fan and
cycle fan
cycle fan
a) These appliances must be tested
to sub-clauses 5.7 and 5.8 of SS
360: 1992.
b) Installation instruction must
mention the 3 expansion bolts for
fastening the main suspension,
safety cord, expansion bolt with
hook for fastening safety cord and
mounting plate. (Appendix Q)
c) Drawing (Appendix P) to show
that the wires within the motor shaft
are not stressed must be provided.
to sub-clauses 5.7 and 5.8 of SS
360: 1992.
b) Installation instruction must
mention the 3 expansion bolts for
fastening the main suspension,
safety cord, expansion bolt with
hook for fastening safety cord and
mounting plate. (Appendix Q)
c) Drawing (Appendix P) to show
that the wires within the motor shaft
are not stressed must be provided.
Only used for DC brushless fans
in
in
apparatus.
N/A
Page 4 of 5
Report No.: 163977
ATTACHMENT 4
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065J
Applicable to portable/wall socket-outlet and portable cable reel
19 Portable/wall
socket-outlet and
portable cable
reel
portable cable
reel
a) If residual current device (RCD)
is incorporated, its tripping current
must be less than 30mA and
operating time must be less than
0.1 second and testing to sub-
clauses 9.9.2.1, 9.9.2.2, 9.9.2.3 and
9.16 of SS 97: Part 1: 2000 are
required.
is incorporated, its tripping current
must be less than 30mA and
operating time must be less than
0.1 second and testing to sub-
clauses 9.9.2.1, 9.9.2.2, 9.9.2.3 and
9.16 of SS 97: Part 1: 2000 are
required.
b) The shutters screening the
current-carrying socket contacts
shall not be opened by the insertion
of any corresponding SINGLE pin
of the plug into any current-carrying
socket aperture.
current-carrying socket contacts
shall not be opened by the insertion
of any corresponding SINGLE pin
of the plug into any current-carrying
socket aperture.
N/A
Applicable to roaster
20
Roaster
A metal ring (Appendix U) must be
provided to prevent the roaster from
falling off in case the glass bowl
shattered.
provided to prevent the roaster from
falling off in case the glass bowl
shattered.
No
roaster
N/A
Applicable to Residual Current Circuit Breaker (RCCB)
31
RCCB
Registration of RCCB is limited to
30 mA sensitivity and the operating
time must be less than 0.1 second.
Electronic RCCB will not be
accepted for registration.
30 mA sensitivity and the operating
time must be less than 0.1 second.
Electronic RCCB will not be
accepted for registration.
No residual current circuit
breaker
breaker
N/A
Applicable to electric instantaneous and storage water heater
32 Instantaneous
electric water
heater and mains
pressure electric
storage water
heater
heater and mains
pressure electric
storage water
heater
Heating elements used must not be
of the "bare-element" type.
of the "bare-element" type.
No electric instantaneous
and storage water heater
and storage water heater
N/A
33 Water
heater
incorporated with
residual current
device(RCD)
residual current
device(RCD)
Testing to sub-clauses 9.9.2.1,
9.9.2.2, 9.9.2.3 and 9.16 of SS 97:
Part 1: 2000 are required.
9.9.2.2, 9.9.2.3 and 9.16 of SS 97:
Part 1: 2000 are required.
N/A
Page 5 of 5
Report No.: 163977
ATTACHMENT 4
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065J
Applicable to multiway adaptor
34 Multiway
adaptor
with 3-pin socket-
outlets or
combination of 3-
pin and 2-pin
socket-outlets
outlets or
combination of 3-
pin and 2-pin
socket-outlets
a) The socket contacts of the
adaptor shall only accept 13A 3-pin
mains plug complying with SS 145
and/or 2.5A 2-pin mains plug
complying with EN 50075.
adaptor shall only accept 13A 3-pin
mains plug complying with SS 145
and/or 2.5A 2-pin mains plug
complying with EN 50075.
b) The shutters screening the
current-carrying socket contacts
shall not be opened by the insertion
of any corresponding SINGLE pin
of the plug into any current-carrying
socket aperture.
current-carrying socket contacts
shall not be opened by the insertion
of any corresponding SINGLE pin
of the plug into any current-carrying
socket aperture.
c) A barrier or other acceptable
means shall be provided on the
engagement surface of the 2.5A 2-
pin socket-outlet of the adaptor to
PREVENT entry of any types of 2-
pin mains plugs except those
complying with EN 50075. (note:
shutters cannot be regarded as
barriers)
means shall be provided on the
engagement surface of the 2.5A 2-
pin socket-outlet of the adaptor to
PREVENT entry of any types of 2-
pin mains plugs except those
complying with EN 50075. (note:
shutters cannot be regarded as
barriers)
d) Adaptor incorporates with switch
would require additional test to sub-
clauses 13.11, 17.1.3 and 18.1.3 of
SS 145: Part 2: 1997.
would require additional test to sub-
clauses 13.11, 17.1.3 and 18.1.3 of
SS 145: Part 2: 1997.
No multiway adaptor
N/A
Applicable to plasma/LCD display monitor
35 Plasma/LCD
display monitor
with TV tuner
with TV tuner
Plasma/LCD display monitor tested
to IEC 60950 would require
additional test to clauses 9 (related
to antenna only), 10.1, 10.2, 10.3
and 12.5 of IEC 60065.
to IEC 60950 would require
additional test to clauses 9 (related
to antenna only), 10.1, 10.2, 10.3
and 12.5 of IEC 60065.
No plasma/LCD display
monitor
monitor
N/A
Page 1 of 1
Report No.: 163977
ATTACHMENT 4
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065J
KOREA NATIONAL DIFFERENCES
Test results according to Online CB BULLETIN (Last modification date of 2008-06-10)
Differences according ................... :
Corresponding National Standard
No.
Requirement – Test
Result - Remark
Verdict
5.101
Other Marking: Wording
or an inf
ormation regulated in IEC Publication 417 giving hi
gh voltage warning to layman shall be marked, if an
apparatus contains a part more than 600 volts.
gh voltage warning to layman shall be marked, if an
apparatus contains a part more than 600 volts.
No high voltage
N/A
15.1.1
Plugs for the connection of the apparatus to the su
pply mains and socket outlets for providing mains p
ower to other apparatus shall comply with the Kore
an requirement (KSC8300 and 8305)
ower to other apparatus shall comply with the Kore
an requirement (KSC8300 and 8305)
Not provided.
See summary of testing.
See summary of testing.
N/A
31.
Radio frequency interference
The apparatus shall comply with the relevant CISP
R requirements (EMC=EMI+EMS)
—