Harman Kardon AVAP 5G User Manual / Operation Manual ▷ View online
Troubleshooting Guide
38
This unit is designed for trouble-free operation. Most problems users encounter are due to operating errors. So, if you have a problem,
first check this list for a possible solution. If the problem persists, consult your authorized Harman Kardon Service Center.
first check this list for a possible solution. If the problem persists, consult your authorized Harman Kardon Service Center.
If the problem is...
Make sure that the...
No lights illuminate when POWER button is pressed
Unit is plugged into a live outlet
Main power switch is pressed in
Main power switch is pressed in
No sound is heard
Unit has not been muted
Correct input function selector button has been pressed
Volume is turned up
Correct input function selector button has been pressed
Volume is turned up
Dolby Surround does not work on center and rear channels
Correct surround mode is selected
Center and/or rear speakers are selected
Rear and center levels are turned up
You are using a surround encoded source
Center and/or rear speakers are selected
Rear and center levels are turned up
You are using a surround encoded source
Selecting a Video source produces sound but no picture
Monitor output is connected to the video input on TV
The TV picture does not match the sound
Video sources are properly connected to receiver
Video/Antenna Switch on TV is set to Video
Video/Antenna Switch on TV is set to Video
No output from one or more channels
Cables are not defective: Check/replace speaker cables
No center channel output
Center channel speaker is selected
Pro Logic mode is selected
Center channel level is properly adjusted
Center speaker is selected
Pro Logic mode is selected
Center channel level is properly adjusted
Center speaker is selected
Tuner sound has a large amount of interference, or
The antenna is properly connected
The “Stereo” display is not illuminated, or
The antenna is properly located
Tuner sound distorts and/or volume level is too low
The antenna is set in the proper direction
The antenna is adequate to receive the desired station
The antenna is adequate to receive the desired station
Tuner is intermittent or continuously buzzing or hissing
The unit is away from fluorescent lights, TVs, motors and
other electrical appliances
other electrical appliances
AVR5 om (e) 2/5/99 10:38 AM Page 38
Technical Specifications
39
Audio Section
Stereo Mode
Continuous Average Power (FTC)
Continuous Average Power (FTC)
45 Watts per channel, 20Hz–20kHz
@ < 0.08% THD, both channels driven into 8 ohms
@ < 0.08% THD, both channels driven into 8 ohms
Five-Channel Surround Mode
35 Watts per channel, 20Hz–20kHz
@ < 0.08% THD, all five channels driven
simultaneously into 8 ohms
@ < 0.08% THD, all five channels driven
simultaneously into 8 ohms
Input Sensitivity/Impedance
Linear (High Level)
200mV/47kohms
Signal-to-Noise Ratio (IHF-A)
92dB
Surround System Adjacent Channel Separation
Analog Decoding (Pro Logic, etc.) 40dB
Analog Decoding (Pro Logic, etc.) 40dB
Frequency Response
@ 1W (+0dB, –3dB)
8Hz–120kHz
High Instantaneous
Current Capability (HCC)
Current Capability (HCC)
±35 Amps
Transient Intermodulation
Distortion (TIM)
Distortion (TIM)
Unmeasurable
Rise Time
16 µsec
Slew Rate
40V/µsec
FM Tuner Section
Frequency Range
87.5–108MHz
Usable Sensitivity
IHF 1.3 µV/13.2dBf
Signal-to-Noise Ratio
Mono/Stereo 70/68dB
Distortion
Mono/Stereo 0.3/0.5%
Stereo Separation
40dB @ 1kHz
Selectivity
±400kHz, 65dB
Image Rejection
40dB
IF Rejection
110dB
Tuner Output Level
1kHz, ±75kHz Dev 500mV
AM Tuner Section
Frequency Range
520–1710kHz
Signal-to-Noise Ratio
43dB
Usable Sensitivity
Loop 500µV/M
Distortion
1kHz, 50% Mod 0.8%
Selectivity
±10kHz, 30dB
Video Section
Video Format
NTSC
Input Level/Impedance
1Vp-p/75 ohms
Output Level/Impedance
1Vp-p/75 ohms
Video Frequency Response 10Hz–8MHz (–3dB)
General
Power Requirement
AC 120V/60Hz
Power Consumption
72W idle, 332W maximum
(2 channels driven)
(2 channels driven)
Dimension (Max)
Width
17.4 inches (442mm)
Height
6.1 inches (156mm)
Depth
16.3 inches (415mm)
Weight
24.6 lbs. (11.2 kg)
Depth measurement includes knobs, buttons and terminal connections.
Height measurement includes feet and chassis.
All features and specifications are subject to change without notice.
*Manufactured under license from Dolby Laboratories.
“Dolby,” “Pro Logic” and the Double-D symbol are
trademarks of Dolby Laboratories. Confidential Unpublished
Works.
“Dolby,” “Pro Logic” and the Double-D symbol are
trademarks of Dolby Laboratories. Confidential Unpublished
Works.
©
1992–1998 Dolby Laboratories, Inc. All rights reserved.
†
DTS is a trademark of Digital Theater Systems, Inc.
††
UltraStereo is a trademark of UltraStereo Corp.
AVR5 om (e) 2/5/99 10:38 AM Page 39
Staple or clip original invoice here. ▼
AVR5 om (e) 2/5/99 10:38 AM Page 40
Printed in Korea
Part #1111-AVR5OM
YIAR-I2000-ZZA
AVR5 om (e) 2/5/99 10:38 AM Page 1
