Sony KDL-32XBR4 / KDL-40D3000 Service Manual ▷ View online
29
KDL-32XBR4/40D3000
KDL-32XBR4/40D3000
KDL-32XBR4 ONLY
CORE BLOCK HARNESS
Route/Dress Harnesses connected to
Core Block as Shown
Core Block as Shown
NOTE Order & Direction of Cables in
plastic Clip on Shield Case.
plastic Clip on Shield Case.
OPERATION PROCESS
2
3
1
1
Keep Cables BELOW level
of Shield Case (Pinch Points)
of Shield Case (Pinch Points)
NOTE order and direction of cables!
DRESS CABLES 1st
DRESS CABLES 2nd
DRESS CABLES 3rd
DRESS CABLES 4th
DRESS CABLES LAST
ON TOP ALL CABLES.
ON TOP ALL CABLES.
30
KDL-32XBR4/40D3000
KDL-32XBR4/40D3000
KDL-32XBR4 ONLY
CORE BLOCK HARNESS (CONTINUED)
Route/Dress Core-Block cables as shown
Put Attention on DIRECTION of cables
in G-Bracket.
Put Attention on the position of the
Side Clamps and routing of the Cables
between Core Block and G1-Bracket.
Put Attention on DIRECTION of cables
in G-Bracket.
Put Attention on the position of the
Side Clamps and routing of the Cables
between Core Block and G1-Bracket.
OPERATION PROCESS
NOTE direction of wires dressed in G-Bracket.
1
1
NOTE Routing of cables and position
of side clamps (HF Cover has marks
for 32" clamp position)
of side clamps (HF Cover has marks
for 32" clamp position)
31
KDL-32XBR4/40D3000
KDL-32XBR4/40D3000
KDL-32XBR4 ONLY
G1H BOARD
1. Install/Wire Dress Harnesses as shown.
2. CAUTION: Make sure INVERTER CONNECTOR
is Fully LOCKED!!
OPERATION PROCESS
1
2
CAUTION:
Make Sure Inverter
Connector is Fully LOCKED!
G-Bd
NOTE: NEW G-Bracket Change!
Inverter wire is NOT dressed in 1st clip.
Inverter wires are dressed in cut-out on
side of the G-Bracket and the 2nd clip on right.
13P harness is NOT dressed in any of the
clips above PWB!
Inverter wires are dressed in cut-out on
side of the G-Bracket and the 2nd clip on right.
13P harness is NOT dressed in any of the
clips above PWB!
32
KDL-32XBR4/40D3000
KDL-32XBR4/40D3000
KDL-32XBR4 ONLY
SPEAKER HARNESS
1. Wire Dress Speaker Cables as shown.
Use UL Tape to align Cables in clip.
FGC-3 CLAMP ELIMINATED
2. Apply LCD TAPE to BOTH H4-Bd AND Right
speaker Wires.
TORQUE: 6kg.cm (+-1.0kg.cm)
TORQUE SPECIFICATION
OPERATION PROCESS
1
2
2
Apply LCD Tape to BOTH H4 AND Right Speaker Wires.
Dress Lt. Speaker Wires in Side Clamp.
NOTE:
FGC-3 CONDUCTIVE CLAMP
NOT UNSED IN FINAL DESIGN
REFER TO ECN #ECC22812
FGC-3 CONDUCTIVE CLAMP
NOT UNSED IN FINAL DESIGN
REFER TO ECN #ECC22812
Click on the first or last page to see other KDL-32XBR4 / KDL-40D3000 service manuals if exist.