Sony KDL-32SL130 / KDL-40SL130 Service Manual ▷ View online
33
KDL-32SL130/40SL130
KDL-32SL130/40SL130
KDL-32SL130 ONLY
1. Dress/Route H1-Bd harness as shown
on photo.
2. NOTE: Put attention on SLACK of cable.
Between Connector on H1 and tape there
is slack in wire.
Between tape/clamp there is slack.
Between tape/DTT Shield there is slack.
OPERATION PROCESS
1
2
NOTE which connector
cables are attached to
on H1-Bd.
cables are attached to
on H1-Bd.
Plastic Side Clamp.
Installed by Vendor.
Installed by Vendor.
2
H1 BOARD
34
KDL-32SL130/40SL130
KDL-32SL130/40SL130
KDL-32SL130 ONLY
1. Route 40P LVDS Cable between
BU-Bd and TCON as shown.
2. Apply 3x8mm Screw (2-places) to ground
LVDS cable.
Put Attention on Routing of Cable.
G1 to BU cables are on TOP of LVDS.
H3-Bd cables are UNDER LVDS.
3mm TORQUE: 6.0kg-cm (+-1.0kg-cm)
OPERATION PROCESS
TORQUE SPECIFICATION
NOTE: LVDS Cable is UNDER G1/U-Bd cables
NOTE: LVDS Cable is ON TOP of H3-Bd Cables
1
2
2
LVDS CABLE
35
KDL-32SL130/40SL130
KDL-32SL130/40SL130
KDL-32SL130 ONLY
Route LVDS Harness from BU-Board
(CN4500) as shown.
CAUTION: Keep LVDS Wires AWAY from
Memory IC and JIG Connectors!
OPERATION PROCESS
CAUTION:
Keep LVDS Cables AWAY from JIG Connectors
and Memory IC.
LVDS CABLE (CONTINUED)
36
KDL-32SL130/40SL130
KDL-32SL130/40SL130
KDL-32SL130 ONLY
Attach ESD Grounding wire as shown
shown.
NOTE: 3x8mm AND 3x5mm Screws are
used!!
TORQUE: 6.0kg.cm (+-1.0kg.cm)
OPERATION PROCESS
TORQUE SPECIFICATION
Install
3x8mm
screw to GND Tab
on RIGHT VESA Bracket.
NOTE: This screw can be applied
off-line as pre-assembly operation.
NOTE: This screw can be applied
off-line as pre-assembly operation.
Install
3x5mm
screw to GND Tab
on panel above BH-Bd Shield Case.
2
1
3
DO NOT install
3x5mm
screw to
GND Tab on lower panel "dimple".
VESA BRACKET GROUND WIRE
Click on the first or last page to see other KDL-32SL130 / KDL-40SL130 service manuals if exist.