Sony KDL-32SL130 / KDL-40SL130 Service Manual ▷ View online
41
KDL-32SL130/40SL130
KDL-32SL130/40SL130
KDL-40SL130 ONLY
1. Dress H4/Rt. Speaker cables in white
side clips.
2. Dress AC Inlet Cables in Plastic clip on the
G-Bracket as shown.
Make sure Green/Yellow Earth Gnd. Is screwed
into lower LCD Bracket (w/4x8mm screw)
OPERATION PROCESS
2
Dress AC Inlet Cables
in plastic clip on G-Bracket
in plastic clip on G-Bracket
NOTE Angle of Earth Gnd. Wire.
(Ring terminal touches "dimple" on plate)
(Ring terminal touches "dimple" on plate)
NOTE BOTH H4-Bd and Rt. Speaker cables
are dressed UNDER AC Inlet
are dressed UNDER AC Inlet
NOTE: H4-Bd/Right Speaker cables
are dressed in plastic clip.
Clip installed by Vendor.
are dressed in plastic clip.
Clip installed by Vendor.
1
H4 BOARD AND RIGHT SPEAKER (CONTINUED)
42
KDL-32SL130/40SL130
KDL-32SL130/40SL130
KDL-40SL130 ONLY
Route/Dress Harnesses connected to
Core Block as Shown
NOTE Order & Direction of Cables in
plastic Clip on Shield Case.
OPERATION PROCESS
2
3
1
1
Keep Cables BELOW level
of Shield Case (Pinch Points)
of Shield Case (Pinch Points)
NOTE order and direction of cables!
Route 1st
Route 2nd
Route 3rd
Route 4th
Route LAST
CORE BLOCK HARNESS
43
KDL-32SL130/40SL130
KDL-32SL130/40SL130
KDL-40SL130 ONLY
Route/Dress Core-Block cables as shown
Put Attention on the position of Sheet
Core C and the routing of the cables
between G3-Bd and Core Block.
OPERATION PROCESS
Apply Sheet Core C to dress cables.
Dress G3-Bd Cables in G-Bracket Clip
1
CORE BLOCK HARNESS (CONTINUED)
44
KDL-32SL130/40SL130
KDL-32SL130/40SL130
KDL-40SL130 ONLY
CAUTION
MAKE SURE BLACK INSULATION
TUBING DOES NOT TOUCH CONN
BEFORE
INSTALLING 2P MD CONN.
AFTER
INSTALLING CONNECTOR, TUBE
INSULATION CAN TOUCH CONNECTOR!
OPERATION PROCESS
N.G.
INVERTER
O.K.
1
G3-
Bd
INSTALL INVERTER SIDE 1ST
INVERTER
1
1
O.K.
N.G.
D1-Bd
D1-Bd
INSTALL D1-Bd SIDE 2ND
1
INVERTER BOARD AND D1 BOARD
Click on the first or last page to see other KDL-32SL130 / KDL-40SL130 service manuals if exist.