Sony KDL-32SL130 / KDL-40SL130 Service Manual ▷ View online
49
KDL-32SL130/40SL130
KDL-32SL130/40SL130
KDL-40SL130 ONLY
Dress LEFT speaker harness as shown
OPERATION PROCESS
1
2
PUSH SIDE CLAMP THIS DIRECTION TO LOCK!!
2
Side Clamp Installed by SBC PLANT!
Side Clamp Installed by Vendor.
LEFT SPEAKER HARNESS
50
KDL-32SL130/40SL130
KDL-32SL130/40SL130
KDL-40SL130 ONLY
1. Apply Sheet Core A to Panel in location
where U2 bracket is to be installed
(Use plastic ribs on bezel as guide)
2. Make sure DTT Shield has Sheet Core C
Install Sheet Core C on "dimple" of panel
to secure cables to panel.
3. Wire Dress 20P Harness as shown.
Put attention on DIRECTION of wires from
BU-Bd inside side clamp on DTT Shield!
OPERATION PROCESS
1
2
Align with center of circles on
panel rib.
panel rib.
Align with ribs on bezel channel
Check Sheet Core C is installed along edge of DTT shield
and start of straight edge of DTT shield.
[INSTALLED BY VENDOR]
and start of straight edge of DTT shield.
[INSTALLED BY VENDOR]
2
3
3/4/2007 LATE CHANGE:
ADD
3x12mm Screw in this
hole!
3
U1 BOARD
51
KDL-32SL130/40SL130
KDL-32SL130/40SL130
KDL-40SL130 ONLY
1. Wire route ESD GND wire as shown
(NOTE: Actual Part will have BLUE insulation)
2. Use 3x12mm screw to fix ring terminal in
U1 Bracket
3. Apply Sheet Core C to hold cable on panel.
Use Bottom of "score line" and "Dimple"
on panel ase guide for aligning tape.
3mm TORQUE: 6.0kg-cm (+-1.0kg-cm)
OPERATION PROCESS
TORQUE SPECIFICATION
1
3
2
U1 BOARD (CONTINUED)
52
KDL-32SL130/40SL130
KDL-32SL130/40SL130
KDL-40SL130 ONLY
1. Dress/Route H1-Bd harness as shown
on photo.
2. NOTE: Put attention on SLACK of cable.
Between Connector on H1 and tape there
is slack in wire.
Between tapes there is a little slack.
Between tape/DTT Shield there is slack.
OPERATION PROCESS
1
2
NOTE which connector
harness is attached to
on H1-Bd.
harness is attached to
on H1-Bd.
Tape no longer
applied to panel!
applied to panel!
2
H1 BOARD
Click on the first or last page to see other KDL-32SL130 / KDL-40SL130 service manuals if exist.