Sony BDP-CX7000ES Service Manual ▷ View online
BDP-CX7000ES
13
2-14. SDO BOARD
5 two screws
(BVTP2.6)
3 screw (PTPWH2.6)
1 screw (PTPWH2.6)
1 Move the slider (pop-up) and the lever (pu joint) fully
in the direction of the arrow
A.
2 Install the gear (cam) in the direction shown
in the illustration and rotate it fully
in the direction of the arrow
B.
3 When the gear (cam) happens to go too deep,
return it to the original position
in the direction of the arrow
C.
4 gear (B)
base (door) block
2 gear (cam)
6 SDO board
C
B
A
lever (pu joint)
two rotary switches
slider (pop-up)
gear (cam)
SDO board
The levers of the two rotary switches on the DOOR SW board
are shown in the illustration below.
are shown in the illustration below.
Precaution during the gear (cam) installation
BDP-CX7000ES
14
2-16. BACK PANEL BLOCK
3 Cut the wire holder.
4 six screws
(BVTP3
u 8)
4 three screws
(BVTP3
u 8)
1 nine screws
(BVTP3
u 8)
4 four screws
(BVTP3
u 8)
2 cover (CDM_T) block
4 four screws
(BVTP3
u 8)
5 back panel block
2-15. POP-UP (400) ASSY
1 screw (PTPWH3 u 6)
chassis block
2 step screw
3 pop-up (400) assy
BDP-CX7000ES
15
2-17. BU (KEM-430AAA) ASSY
6 four screws
(BVTP3
u 8)
6 four screws
(BVTP3
u 8)
6 two screws
(BVTP3
u 8)
0 two screws
(BVTP3
u 8)
qa BU (KEM-430AAA) assy
Note: Refer to the servicing notes “NOTE
THE OPTICAL PICK-UP BLOCK
AND DR-510 BOARD REPLACING”
(page 4), if replacing this part.
3 SATA harness (CN001)
5 sarannet cushion (SQ)
4 connector
(CN900)
1 three screws
(BVTP3
u 8)
2 bracket (corner)
7 bracket (top BD) block
8 torsion holder (magnet) block
9 torsion spring (MG)
BDP-CX7000ES
16
2-18. OPTICAL PICK-UP BLOCK (KEM-430AAA)
Note: Refer to the servicing notes “NOTE THE OPTICAL PICK-UP BLOCK AND DR-510 BOARD REPLACING” (page 4) if replacing the opti-
cal pick-up block or DR-510 board.
8 optical pick-up block
(KEM-430AAA)
1 flexible flat cable
(CN521)
6 two float screws (S)
Align as the same length.
flexible flat cable
Bend down the edge.
flat clamp
side view
6 two float screws (S)
7 two insulators
7 two insulators
2 flexible flat cable
(CN301)
4 flexible flat cable
5 flat clamp (20)
3 DR-510 board block
Arrangement of flexible flat cable
Click on the first or last page to see other BDP-CX7000ES service manuals if exist.