Sony SAL100M28 Service Manual ▷ View online
SAL100M28 (MACRO 2.8/100) (100mm F2.8 Macro)
HELP
Apply the grease
(G-15) (All circumference)
(G-15) (All circumference)
Apply the grease
(G-15) (All circumference)
(G-15) (All circumference)
Apply the grease (G-15)
Apply the
anti-diffusion agent (A-20)
(All circumference)
anti-diffusion agent (A-20)
(All circumference)
HELP09
Grease (G-15):
J-6082-619-A
Anti-diffusion agent (A-20): J-6082-611-A
Apply the grease (G-15) and anti-diffusion agent (A-20) to the instruction part of the focus operation ring.
SAL100M28 (MACRO 2.8/100) (100mm F2.8 Macro)
HELP
HELP10
Adhesive bond (B-10): J-6082-612-A
1.
Attach the scissors lever block.
2.
Turn the adjustment screw until the float ring rotate smoothly without rattling.
3.
Assemble the focus operation ring.
4.
Check the operation of the focus operation ring, and apply the adhesive bond (B-10) as shown in the figure.
Screw
Adjustment Screw
Torque Ring
Float Ring
Pinch Lever
Apply the adhesive bond (B-10)
Focus Operation Ring
SAL100M28 (MACRO 2.8/100) (100mm F2.8 Macro)
HELP
HELP11
Grease (F-10): J-6082-631-A
1.
Apply the grease (F-10) to the instruction part of the fixed holding tube block.
2.
Cut the OHP film to the size large enough to cover the lens block, then wind it as shown in the figure.
5 mm
Apply the grease (F-10)
(All circumference)
(All circumference)
OHP Film
SAL100M28 (MACRO 2.8/100) (100mm F2.8 Macro)
HELP
3.
Install the fixed holding tube block down to the position as shown in the figure, then pull the OHP film off to remove.
Note:
When installing the fixed holding tube block, do not damage the switch shown in the figure.
HELP12
Grease (F-10):
J-6082-631-A
Adhesive bond (B-40): J-6082-614-A
1.
Apply the grease (F-10) to the instruction part of the float ring.
2.
Attach the float ring, and apply the adhesive bond (B-40) to the three screws and tighten them as shown in the figure.
OHP Film
Torque Ring Support Barrel
Torque Spring
Orient the focus range stopper as illustrated.
Install the fixed holding tube block while
slightly warping it from the both sides.
slightly warping it from the both sides.
Switch
Apply the
adhesive
bond (B-40)
adhesive
bond (B-40)
Apply the
adhesive bond (B-40)
adhesive bond (B-40)
Apply the grease
(F-10) (All circumference)
(F-10) (All circumference)
Apply the grease
(F-10) (All circumference)
(F-10) (All circumference)
Click on the first or last page to see other SAL100M28 service manuals if exist.