DOWNLOAD Sharp MX-M266N / MX-M316N / MX-M356N (serv.man4) Service Manual ↓ Size: 26.56 MB | Pages: 76 in PDF or view online for FREE

MX-M356NV  MX-FN26 N (FINISHER)  7 – 1

MX-M356NV

Service Manual

 

MEMO: When removing the finisher, put your hand beneath the
unit and lift it up as shown below.

Check to confirm that all the packed parts are provided.

NOTE: Turn off the main switch of the machine and then remove

the power plug of the machine from the outlet.

1)

Open the front cover.

2)

Remove the screws, and remove the left cabinet.

3)

Remove the paper holding arm. 
The paper holding arm must be removed together with the
paper holding arm holder. Since the paper holding arm is easy
to remove alone, be careful not to leave the paper holding arm
holder unremoved.

4)

Remove the actuator. 

FIN connection unit

FIN front cover

Second paper exit unit

Paper holding arm

M3 x 8 S tight bind

(4 pcs.)

M4 x 8 S tight bind

(2 pcs.)

Resin grip

Staple position label

Earth cable fixing 
screw
M3 x 8 S tight bind

(1 pcs.)

Hexagonal screw

(2 pcs.)

Second paper exit 
right door unit

FIN transmission 
harness

Conversion harness  (Not use)

MX-M356NV  MX-FN26 N (FINISHER)  7 – 2

5)

Remove the screw which are fixing the paper exit tray.
Remove the paper exit tray.

6)

Remove the paper exit rear cabinet support plate.

7)

Remove the screws, and remove the front cabinet left.

8)

Remove the paper exit dummy cover.

MX-M356NV  MX-FN26 N (FINISHER)  7 – 3

9)

Remove the screw and remove the rear cabinet.

10) Remove the right cabinet middle unit. 

11) Pass the harness (packed together with the unit) of the second

paper exit unit though the cable saddle and inside of the frame
plate as shown in the figure.

Install the second paper exit unit to the machine, and fix it with
the M4 screws which are packed together with the finisher.
Connect the connector of the harness.

12) Connect the connector of the harness to the PWB.

13) Remove the current the second paper exit right door unit and

fix the bundled second paper exit right door unit to the right
cabinet middle unit. 

14) Fix the right cabinet middle.

MX-M356NV  MX-FN26 N (FINISHER)  7 – 4

15) Remove round-head screw from the connection unit which is

packed with the finisher, and remove the front cabinet lower
and the connection cabinet temporarily.

16) Slide the rail under the connection unit to the lock position.

17) Engage the finisher connection plate with the notch in the stay

at the right bottom of the machine.

Slide the connection plate to the bottom, and attach M3 screw
as shown. (Use the screw bundled to the package.) 

MEMO: Press the right side of the connection plate.

MEMO: The black mylar should not be on the metal plate of
MFP.

18) After attaching the screw, pull the connection plate toward you.

MEMO: When holding the finisher, hold the front frame side
and the rear frame side.

19) Insert the finisher along the connection plate rail from the left

side of the machine until it locks.

20) Press the finisher from the front to slide to the rear together

with the connection plate.

MEMO: Press the right side of the connection plate.