Sharp MX-BMX1 (serv.man3) Service Manual ▷ View online
BF-3-1
Replacement
Adjustment
20 October 2010
COVERS
3 REPLACEMENT AND ADJUSTMENT
3.1 COVERS
3.1.1 FRONT COVER
[A]
Removal
1. Open top cover.
2. Remove screws [A] ( x 3 ).
3. Remove screws [B] ( x 2 )
1. Open top cover.
2. Remove screws [A] ( x 3 ).
3. Remove screws [B] ( x 2 )
[A]
[B]
BF-3-2
20 October 2010
COVERS
3.1.2 REAR COVER
[A]
[A]
Removal
1. Loosen screws [A] ( x 2 ).
1. Loosen screws [A] ( x 2 ).
NOTE: Lift out lower part and unhook the Rear cover.
BF-3-3
Replacement
Adjustment
20 October 2010
COVERS
3.1.3 INFEED COVER
[A]
Removal
1. Open Top cover.
2. Remove nuts [A] ( x 4 ).
3. Remove nuts [B] and remove locking bracket ( x 2 ).
4. Tilt machine (
1. Open Top cover.
2. Remove nuts [A] ( x 4 ).
3. Remove nuts [B] and remove locking bracket ( x 2 ).
4. Tilt machine (
3.1.6 ).
5. Remove nuts [C] ( x 2 ).
Replacement
4. Reverse the removal procedure.
4. Reverse the removal procedure.
NOTE: Make sure that the springs to the Upper Transport Belts are in correct
position, see operator manual.
[A]
[C]
[B]
Bottom view
BF-3-4
20 October 2010
COVERS
3.1.4 OUTFEED COVER
[A]
Removal
1. Remove Top cover gas spring lower end from joint [A].
1. Remove Top cover gas spring lower end from joint [A].
NOTE: Press plastic stud from pivot point.
2. Loosen screws [B] ( x 2).
3. Remove screws [C] ( x 2).
4. Remove upper part of outfeed cover.
5. Remove Belt Stacker hangers and washers [D] ( x 2, x 2).
6. Remove screws [E] ( x 2).
7. Remove screws and washers [F] ( x 2, x 2).
8. Lift Out feed cover plates carefully and disconnect wiring to sensor Q7 Pho-
3. Remove screws [C] ( x 2).
4. Remove upper part of outfeed cover.
5. Remove Belt Stacker hangers and washers [D] ( x 2, x 2).
6. Remove screws [E] ( x 2).
7. Remove screws and washers [F] ( x 2, x 2).
8. Lift Out feed cover plates carefully and disconnect wiring to sensor Q7 Pho-
totransistor [G] (
x 1).
9. Remove lower part of outfeed cover.
[B]
[D]
[C]
[F]
[E]
Click on the first or last page to see other MX-BMX1 (serv.man3) service manuals if exist.