DOWNLOAD Sharp MX-BMX1 (serv.man3) Service Manual ↓ Size: 5.58 MB | Pages: 86 in PDF or view online for FREE

Model
MX-BMX1 (serv.man3)
Pages
86
Size
5.58 MB
Type
PDF
Document
Service Manual
Brand
Device
Copying Equipment / Square Fold Unit - (MX-FDX1)
File
mx-bmx1-sm3.pdf
Date
PREV: Sharp MX-BMX1 (serv.man2) Service Manual

Sharp MX-BMX1 (serv.man3) Service Manual ▷ View online

BF-3-5
Replacement
Adjustment
20 October 2010 
COVERS
[G]
BF-3-6
20 October 2010
COVERS
3.1.5  TOP COVER
Removal
1.  Open Top cover.
2.  Remove Top cover gas spring lower end from joint [A].
 
NOTE: Press plastic stud from pivot point.
3.  Remove screws [B] (   x 4).
Bad
Top cover too low
Good
Bad
Top cover too high
[B]
[A]
BF-3-7
Replacement
Adjustment
20 October 2010 
COVERS
3.1.6  TILT THE MACHINE
Removal
1.  Remove Belt stacker ( Service manual MX-BMX1 
 3.8.1).
2.  Remove the Trim bin.
3.  Remove the Service bracket [A] by removing two nuts (   x 2 ).
4.  Remove the foot screw [C] and mount it in the oposite hole up-side-down.
5.  Place the Service bracket [B] in the Book folder base.
6.  Turn foot screw [C] on the Service bracket, until the Service bracket firmly  
contacts the floor.
7.  Remove the screw [D] securing the machine with the base.
8.  Remove Front cover ( 
 3.1.1).
9.  Remove Rear cover ( 
 3.1.2).
10. Loosen screws [E] half a turn. One on each side (   x 2).
[A]
[B]
[C]
[D]
WARNING
Book Folder may Tip. Install Service bracket before separating the Book
Folder from the Trimmer.
WARNING
Before tilting make sure pivot screws [E] are NOT tightened.
Infeed view
Infeed view 
from below
BF-3-8
20 October 2010
COVERS
11. Remove screws [F]. One on each side (   x 2). 
NOTE: Keep the screws. They will be used later in this procedure.
[F]
Front view
Rear view
Front view, 
machine tilted
Rear view, 
machine tilted
CAUTION
When lowering or raising the machine, lift in infeed area only.
[G]
[E]
12. Tilt machine by lifting infeed cover.
13. Secure machine with both the screws [G]. One on each side. Use the screws 
previously removed from [F]. (   x2).
WARNING
When tilting MX-FDX2, make sure to tighten BOTH screws [G],
one on each side.
Page of 86
Display

Click on the first or last page to see other MX-BMX1 (serv.man3) service manuals if exist.

RANDOM: