Sharp MX-BMX1 (serv.man3) Service Manual ▷ View online
BF-3-13
Replacement
Adjustment
20 October 2010
MOTORS
3.2.3 CLAMP MOTOR (M3)
Removal
1. Remove Outfeed Cover (
1. Remove Outfeed Cover (
3.1.4 ).
2. Remove the E-Clips and Washers [A] ( x 2, x 2).
3. Remove the driving disc [B] by loosening allen screw ( x 1).
4. Disconnect the motor connectors (
3. Remove the driving disc [B] by loosening allen screw ( x 1).
4. Disconnect the motor connectors (
x 2).
5. Remove screws [C] holding Motor bracket ( x 4).
6. Remove screws holding Motor bracket ( x 3).
6. Remove screws holding Motor bracket ( x 3).
Replacement
1. Mount Motor to Motor bracket ( x 3).
2. Reinstall motor, by tighten screw [C] ( x 4).
3. Connect the motor connectors (
1. Mount Motor to Motor bracket ( x 3).
2. Reinstall motor, by tighten screw [C] ( x 4).
3. Connect the motor connectors (
x 2) .
NOTE: The Orange wire on ”1”, and the Violet wire on ”2”.
4. Reverse the rest of the removal procedure.
M3
[A]
[C]
[C]
[B]
[C]
CAUTION
Be careful not to damage sensor SF-Q4
[SF-Q4]
BF-3-14
20 October 2010
MOTORS
3.2.4 ROLLER MOTOR (M4) AND PRESSURE ROLLER
Changing of wear point
The wear point is the area on the roller that strikes the Booklet first, as the roller
The wear point is the area on the roller that strikes the Booklet first, as the roller
moves from the home position (left and right).
1. Remove outfeed cover (
1. Remove outfeed cover (
3.1.4).
2. Move Roller Motor Assembly towards center of clamps.
3. Stop Pressure Roller from moving by pressing with your fingers towards the
3. Stop Pressure Roller from moving by pressing with your fingers towards the
Pressure Roller and out from the Clamps.
4. Move Roll Motor Assembly 20 to 30 mm’s (1”) sideways.
M4
BF-3-15
Replacement
Adjustment
20 October 2010
MOTORS
Removal
1. Remove Outfeed cover (
1. Remove Outfeed cover (
3.1.4).
2. Disconnect Motor plug M4, and sensor plug J26 [A] from wire harness (
x 2).
3. Move Roller Motor assembly towards centre of the clamps.
4. Remove E-Clips [B] ( x 2).
5. Lift out Motor and Pressure Roller [C] upwards.
6. Cut cable ties [D] all the way to connectors, when removing complete Motor.
4. Remove E-Clips [B] ( x 2).
5. Lift out Motor and Pressure Roller [C] upwards.
6. Cut cable ties [D] all the way to connectors, when removing complete Motor.
M4
[B]
O-rings
[C]
[D]
[A]
Rear view
Outfeed view
Page intentionally blank
Click on the first or last page to see other MX-BMX1 (serv.man3) service manuals if exist.