Sharp MX-BMX1 (serv.man2) Service Manual ▷ View online
Replacement Adjustment
20 October 2010
TR-3-9
3.1.9 PROTECTION COVER
COVERS
Removal
1. Lift out scrap paper bin [B].
2. Remove screws [A] ( x4).
1. Lift out scrap paper bin [B].
2. Remove screws [A] ( x4).
Replacement
1. Place the front end of the cover up against the lower knife beam [C].
2. Push in cover so it hooks onto the screws [D].
3. Mount screws [A] ( x4).
1. Place the front end of the cover up against the lower knife beam [C].
2. Push in cover so it hooks onto the screws [D].
3. Mount screws [A] ( x4).
[A]
[B]
[C]
Replacement Step 1.
[D]
Replacement Step 2.
TR-3-10
20 October 2010
COVERS
3.1.10 INTERLOCK MECHANISM
Removal
1. Remove screws [A] ( x 2).
2. Remove interlock mechanism bracket [B].
1. Remove screws [A] ( x 2).
2. Remove interlock mechanism bracket [B].
Replacement
1. Reverse the removal procedure.
1. Reverse the removal procedure.
Adjustment
1. Make sure interlock box is mounted correctly (
1. Make sure interlock box is mounted correctly (
3.1.7).
2. Loosen nuts [A] ( x2).
3. Adjust the interlock mechanism [B] so that it is parallel to the Top cover and so
3. Adjust the interlock mechanism [B] so that it is parallel to the Top cover and so
that the interlock switch is actuated 2 mm before Top cover is closed measu-
red on front side beneath handle.
4. Tighten nuts [A] ( x2).
[A]
[B]
Replacement Adjustment
20 October 2010
TR-3-11
3.2 AREA C
3.2.1 INFEED SENSOR Q13
AREA C
1. Undock the Trimmer.
2. Remove nuts [A] inside bracket holding the Sensor bracket ( x2).
3. Remove connector from the Sensor (
2. Remove nuts [A] inside bracket holding the Sensor bracket ( x2).
3. Remove connector from the Sensor (
x1).
4. Remove sensor [B].
[A]
[B]
TR-3-12
20 October 2010
3.2.2 CONTROL SWITCH S2
AREA C
Removal
1. Remove Rear cover (
1. Remove Rear cover (
3.1.1).
2. Remove connectors [A] (
x2).
3. Remove screws [B] ( x2 ).
Replacement
1. Reverse the removal procedure.
1. Reverse the removal procedure.
Adjustment
1. Lift the Infeed shaft.
2. Make sure the Switch activates slightly before the shaft latches in upper posi-
1. Lift the Infeed shaft.
2. Make sure the Switch activates slightly before the shaft latches in upper posi-
tion.
3. To adjust, loosen screws [B] ( x2 ).
4. Reposition switch to obtain adjustment.
5. Tighten screws [B] ( x2 ).
4. Reposition switch to obtain adjustment.
5. Tighten screws [B] ( x2 ).
[A]
[B]
Click on the first or last page to see other MX-BMX1 (serv.man2) service manuals if exist.