Sharp MX-BMX1 (serv.man2) Service Manual ▷ View online
Replacement Adjustment
20 October 2010
TR-3-5
3.1.5 LOCKING BRACKET
COVERS
[A]
[B]
Removal
1. Loosen nuts [A] ( x2).
2. Locking bracket will fall down.
Replacement
1. Push Trimmer against Bookletmaker.
2. Push up Locking bracket so it latches studs [B].
3. Tighten nuts [A] ( x2).
[B]
TR-3-6
20 October 2010
3.1.6 UPPER OUTFEED COVER
COVERS
1. Remove Belt stacker.
2. Remove Front and Rear cover (
2. Remove Front and Rear cover (
3.1.1).
3. Open the Top Cover.
4. Remove the Gas spring [A] by prying it off using a screw driver.
5. Remove connector [B] (
4. Remove the Gas spring [A] by prying it off using a screw driver.
5. Remove connector [B] (
x1).
6. Cut cable ties [C] inside cover.
7. Remove screws [D] ( x5).
8. Remove screws [E] ( x5).
7. Remove screws [D] ( x5).
8. Remove screws [E] ( x5).
[A]
[C]
[B]
[D]
[E]
Replacement Adjustment
20 October 2010
TR-3-7
3.1.7 INTERLOCK SWITCH S9 &S10
COVERS
Removal
1. Remove connector [B](
1. Remove connector [B](
x1).
2. Remove nuts [A] ( x2).
Replacement
1. Reverse the removal procedure.
1. Reverse the removal procedure.
Note: Mount the interlock box to its uppermost position.
Adjustment
1. Check adjustment according to (
1. Check adjustment according to (
3.1.10).
[A]
[B]
WARNING
Overriding or cheating the interlock allows the MX-TMX1 system to operate
with the top cover open which can result in personal injury. Never give the
operator access to the cheater or show how ovverriding the interlock sys-
tem is carried out.
tem is carried out.
TR-3-8
20 October 2010
3.1.8 LOWER OUTFEED COVER
COVERS
1. Remove Belt stacker (
3.8.1).
2. Remove Front and Rear cover (
3.1.1).
3. Remove Protection Cover (
3.1.9).
4. Loosen screws [A] ( x2).
5. Remove screws [B] ( x4).
5. Remove screws [B] ( x4).
[B]
[A]
[B]
Click on the first or last page to see other MX-BMX1 (serv.man2) service manuals if exist.