Sharp MX-3050N / MX-3060N / MX-3070N / MX-3550N / MX-3560N / MX-3570N / MX-4050N / MX-4060N / MX-4070N (serv.man7) Service Manual ▷ View online
MX-4070V MX-PN15B/C/D (PUNCH MODULE) 12 – 6
24) Fix the front side with the screw.
25) Install the resist sensor (Packed item No.2).
26) Insert the resist sensor (Packed item No.2) from the right side of
the finisher.
27) Fix the resist sensor (Packed item No.2) to the frame of the fin-
isher with the screw.
28) Connect the connector, fix it to the wire saddle.
Check that the guide plate
passes through.
passes through.
Front side
Right side
Resist sensor (No.2) connector
Hopper (no.4) connector
MX-4070V MX-PN15B/C/D (PUNCH MODULE) 12 – 7
29) Install the punch unit (Packed item No.1).
30) Turn the punch unit with the operation section facing upward.
31) Insert the punch unit from the right side of the finisher.
32) Fix the punch unit to the frame of the finisher with the screws (x2).
33) Attach the stepping motor (Packed item No.7) from the right side
of the finisher.
34) Fix the stepping motor (Packed item No.7) to the frame of the fin-
isher with the screws (x2).
35) Connect each harness with the punch unit PWB.
Stepping motor (No.7) connector
Resist sensor (No.2) connector
MX-4070V MX-PN15B/C/D (PUNCH MODULE) 12 – 8
36) Connect the harness (Packed item No.8: Shorter harness) with
the punch unit PWB.
37) Connect the opposite side of the harness (Packed item No.8:
shorter harness) with the interface connector.
Stepping motor (No.7) connector
Resist sensor (No.2) connector
Harness (No.8)
Harness (no.8)
Harness (no.8)
MX-4070V MX-PN15B/C/D (PUNCH MODULE) 12 – 9
38) Pass the harness through the wire saddle.
39) Tie the harness, and pass it through the wire saddle so that it can
be fixed tightly.
40) Install the rear cabinet of the finisher with the screw.
41) Insert the hopper from the front side of the finisher, and push the
hopper as far as it goes.
42) Cut the cover section of the finisher shown in the figure below with
the nipper.
43) For MX-FN29 (Saddle finisher), connect the interface connector
connected to the inner cover.
Click on the first or last page to see other MX-3050N / MX-3060N / MX-3070N / MX-3550N / MX-3560N / MX-3570N / MX-4050N / MX-4060N / MX-4070N (serv.man7) service manuals if exist.