Sharp MX-2300N / MX-2700N / MX-2300G / MX-2700G / MX-2300FG / MX-2700FG (serv.man18) User Manual / Operation Manual ▷ View online
48
Removing staple jams
Follow the steps below to remove a staple jam.
1
While pulling the lever, slide the saddle
stitch finisher to the left until it stops.
stitch finisher to the left until it stops.
2
Open the front cover.
3
Turn roller rotating knob B as shown
until the blue indicator is visible.
until the blue indicator is visible.
4
Remove any paper from the stapler
compiler.
compiler.
Be careful not to tear the paper during removal.
5
If the saddle stitch function was being
used, open the saddle stitch section
cover.
used, open the saddle stitch section
cover.
Blue
Roller rotating knob B
49
6
Remove the misfed paper.
Be careful not to tear the paper during removal.
7
Close the saddle stitch section cover.
8
Pull out the stapler section.
Pull out until the stapler section until it stops.
9
Turn roller rotating knob A in the
direction of the arrow to move the staple
unit out to the front.
direction of the arrow to move the staple
unit out to the front.
Turn the roller rotating knob until the triangle mark is aligned
with the indicator.
with the indicator.
10
Remove the staple case.
11
Raise the lever at the front end of the
staple case and remove the jammed
staple.
staple case and remove the jammed
staple.
Remove the leading staple if it is bent. If bent staples remain, a
staple jam will occur again.
staple jam will occur again.
Roller rotating knob A
Staple unit
50
12
Return the lever to its original position.
13
Replace the staple case.
Push the staple case in until it clicks into place.
14
Push the stapler section back in.
Push the stapler section back in until it locks into its original
position.
position.
15
Close the front cover.
16
Push the saddle stitch finisher back and
latch it to the machine.
latch it to the machine.
Make a test print or copy in staple sort mode to verify that stapling takes place correctly.
51
Discarding punch waste (when a punch module is installed)
1
While pulling the lever, slide the saddle
stitch finisher to the left until it stops.
stitch finisher to the left until it stops.
2
Pull out the punch waste box and
discard the punch waste.
discard the punch waste.
Discard the punch waste in a plastic bag or other container,
taking care not to let the waste scatter.
taking care not to let the waste scatter.
3
Return the punch waste box to its
original position.
original position.
4
Push the saddle stitch finisher back and
latch it to the machine.
latch it to the machine.
Click on the first or last page to see other MX-2300N / MX-2700N / MX-2300G / MX-2700G / MX-2300FG / MX-2700FG (serv.man18) service manuals if exist.